20 Most Recent
Maytag Neptune Washer - Page 2 Questions & Answers
Leaking Washer
There is a pump underneath the machine. The pump might be bad. Pretty easy fix. It was a top load washer.
Washer wont start back up after breaker blew
If it blew the breaker then something inside has shorted out. You should definitely not use it until a qualified engineer has opened it inspected and measured and determined the cause of the short.
Maytag neptune fav6800 will not
The water level sensor hose may be blocked. This is a thick hose that taps down into a thin tube which connects to the water level sensor in the control space.
Check the hose for blocks.
Check the sensor is working by blowing into it and listening for clicking sound indicating switches inside are working. Test resistance across the sensor while blowing into it to make sure.
But first check the hose, this most often causes this particular fault.
Maytag neptune washer code nd,
nd means not draining. u may to check the plastic drain pipe in back to back sure it doesnt have a kink in it, and that it is placed so that the pump inside the washing machine doesn't have to pump it too far to get to the drain.
A string from one of the clothes got stuck in the lock mechanism and the door won't unlock
If the door fails to unlock after 11 attempts, you will see the "LO" code. If this was caused by foreign matter infiltrating the latch area try this. Open the dispenser lid and look for a plastic cord tucked away towards the front. It's the same as "weed whacker" cord. Grasp this cord firmly and pull it from right to left (away from the latch). This is the emergency cord to open the door after a latch failure. remove any debris that would hamper the operation of the latch assembly. Close the door and try going into a spin cycle to check the door lock operation.
Not finding what you are looking for?