Hello This is usually due to a bad door switch.The switch is there to stop the washer during the drain and spin cycle when you open the door to prevent injury.
If it is not working prior to drain and spin the machine will not finish.You can jump the switch out but its better to replace it.
In order to determine the manufacture date you need the serial number not the model number.
The first letter represents the year and the second letter represents the month. These will be the 9th and 10th characters in the serial number respectively.
Leveling: Ensure the washer is properly leveled. An unbalanced load can trigger the UL (unbalanced load) code. Use a level to check if the machine is sitting evenly on the floor.
Load Distribution: Make sure the clothes are evenly distributed in the drum. An imbalanced load can cause the UL code to appear.
Calibration: Some models have a calibration mode that can be accessed through the control panel. Running a calibration cycle might help the washer to detect load balance more accurately.
Electronics: There could be an issue with the control board or wiring harness. Inspect these components for any visible damage or loose connections.
Professional Service: If none of the above steps resolve the issue, it may be time to consult with a professional appliance repair technician who can diagnose and fix the problem more accurately. They may have specialized tools and knowledge to pinpoint the exact cause of the UL code.
Ld is long drain, so either the pump is blocked, the pump impeller is worn or the drain hose is blocked.
I had a drain blockage on a Miele and it was cause by an apple stalk lodging itself across the ridges of the drain hose and had collected enough lint to block it, This was a machine that was washing towels commercially for 16 hours a day.
Unhook the drain and watch it pumping either into a bucket or into a laundry sink. It should fly out in a jet!
..
If yours is a top loader it will mounted near the drum inside the machine. It will be a shaped block of concrete curved to sit close the actual drum. The most like places will be at the front, nearest you when your putting clothes in it, at about 3/4 of the way off the floor. It could also be in a similar place at the back of the machine.
Unfortunately, if you can't get to it, you need a new machine. Normally you would seal with silicone or epoxy putty. The only thing I can can think of is injecting polyurethane expanding foam into the area, but go easy it expands for 10 minutes and you would have to shield any moving parts.
Most parts are obsolete.
notify a repair company for quotes or online search for part ----fixya is an online repair forum we dont send repair personal out or sell manufacture or ship products
Unplug your washing machine for a few minutes which will let the electrical charge to dissipate from your washing machine that will let it reset then. If it is still not working unplug it for 10 minutes.Or you will have to access the real switch then which is under the lid housing by pushing the washing machines drum to the back.
If the washer works with the water temperature set to warm or other setting different from what you normally use, something is wrong with the water fill solenoid valve for your usual setting (warm turns on both valves). A stuck or clogged valve would probably buzz, but a burned-out valve solenoid would be silent. The timer is waiting for a signal from the water level sensor switch, so if no water is coming in, it'll wait all day.
If that isn't it, check the terminals on the wires going to the lid switch for corrosion. Next, check the power switch (operated by pulling the knob out) at the controller/timer unit. (I assume that since you replaced the lid switch you know to unplug the machine before digging into it.) You'll want an ohmmeter to test continuity and contact resistance, or at least a continuity tester. Also check the power wiring where it goes between the washer and dryer sections.
The problems of buying 'Universal'. Some need the correct OEM part because of the mountings.
Google
Maytag (model number) parts
Those simple three words will find you suppliers and within their model page search 'water inlet valve'.
..
