20 Most Recent Maytag MDB7100AWB Dishwasher - Page 4 Questions & Answers

hold the heated dry button for till that light goes out. then try to start. it is a child lock that is on

There should be a heated dry button under options.Hope this helps.https://www.maytag.com/digitalassets/MLPDF/Use%20and%20Care%20Guide%20-%206-917071.pdf

Well first I would have to know if the dishwasher is actually flowing with water or not. If their is no water flowing out then you probably just have a blocked line from deposits in the water. If you are getting water but the dishes arent getting clean then you probably have a bearing out on the wash rotor. hope that helps.

see this causes and fix it. God bless you Float Switch The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the tutorial and the video for checking this part. Timer / Control If your dishwasher gets stuck in a cycle first try shutting off the breaker for at least 5 minutes if this does not correct the problem you will need to replace the timer / electronic control.

http://kitchen.manualsonline.com/manuals/mfg/maytag/mdb7100aws.htmlPerhaps this will be similar??

first of all they wont give you any specs on circuit boards for most appliances,they just want you to replace the board besides that,if a resistor burnt its because there was a heavy current draw on another component that is supplied by this resistor and you would need to locate this defective part such as a motor/solenoid/heater or the new resistor will end up in the same manner,the 2 oozing parts are probably capacitors leaking their die-electric compound from heat and age so they are in need of replacement too,you might go online and ask somebody with a board like yours for the part values,but still you need to find the main problem for the problem on the board first

I had the same problem today - they replaced my telephone pole yesterday and had the power shut off for a couple hours. All light blinked when door closed. I reset by pressing the "drain/off" button for 15 seconds.(found info. on another site) Seems to be ok now

Warn out close sensor arm. Locate it on door and put a small sticky pad on it to push sensor switch a bit farther. If that works, the adjusting the sensor switch position may be necessary.

some models the drain pump pulses before it drains, let it run and see what happens.

pull harder. straight up at the middle