20 Most Recent Maytag 24 in. MDB9750AW Dishwasher - Page 9 Questions & Answers

clean the seal real good with a damp rag, check it for tears or other problems, make sure the door hinges do not have loose screws.

Replace the rinse relay

A defective panel circuit board.

http://www.appliancepartspros.com/whirlpool-filter-pump-wp99001791-ap6014379.html Watch the video on the page

Check the drain line from the washer out, to the drain in the sink. Some how the restriction is causing residue to backup and your not getting a free flow out to the drain. If its a HOSE, disconnect it and blow it out with a vacuum and replace again.

The filters are probably plugged. This will require removing the lower spray arm and cleaning the screens or its possible your not getting enough water in the dishwasher which will cause th upper spray arm to not turn

sounds like the pump is shot.

Adrin, you might want to try this site repairclinic.com for parts.. https://www.youtube.com/watch?v=R0NHki-NnHg video probably broken latch or bad hinges .hope this helps a little

hi Christine. see if this link helps you out. portable maytag dishwasher is locked and cannot open it Google Search

Unplug from power and see if this resets the control panel. Good luck.

there is one or more wire shorting out [frying]. If you can access the wiring system you will see the wire[s] that have been burnt through the plastic covering. You really shouldnt use it until you get it fixed as it could catch fire.You now have one or more exposed, "hot" wire being exposed to other wires when the machine is on. Plastic burns quite easily. Its not the element. Thats just an accumulation of "salts" from the dishwashing detergent. If you want you can gently wipe an element with a damp cloth. [do the same with your stove and oven elements too]

There are several possible problems that could cause this. The first step to diagnose the problem is to disconnect the washer from power. You will probably need to shut power off at the circuit breaker panel and leave it shut off for at least three minutes. This ought to clear the memory of the logic board (computer) in the machine. When you reset the breaker, the machine could work. The problem could also be in the panel controls themselves and Maytag has replaced some of these panels. Your washer might be one that should have a new panel from Maytag and you can find this out by contacting Maytag through their website.