20 Most Recent Maytag MSD2758GEW - Page 5 Questions & Answers

You need an engineer. That sounds like a 'Clixxon', a device that cycles the compressor on and off due to overheated gasses in the system. Do you have cats or dogs? Is the condenser coils in the bottom of the unit clean? This page covers 'clicking sounds'. https://www.google.com/search?q=maytag+fridge+making+clicking+noise ..

possible bad compressor or low coolant or bad temp sensor

Yes. You probably hearing cold air being circulated.

No did u take a reading w a carpentr level. Cud hav tumuch stuf init also

The handle screws probably are hidden behind the plastic door liner which would have to be removed to gain access.

Spray it with kitchen cleaner. Scrub it with a Scotchbrite pan scourer to remove oxidisation. Spray it again, rub, rinse, and dry. Rub Vaseline on it. It will probably outlast you. If it did fail, the copper tube will pit and let the refrigerant gas leak out slowly until one day you find it isn't cooling. A refrigeration engineer could replace the pipe and re-gas it, but at 18 years old, it would be time to treat yourself to a new one. Whoever did the soldering didn't wipe off the flux, which is acidic.

The ice maker is defective and should be repaired/replaced.

The defrost water drainage and evaporation system is malfunctioning.

YOU NEED TO CALL A LOCAL REPAIR SERVICE

probably needs freon added and you need a tech for that

I would let it thaw out and try again.

SOME FRIDGES HAVE A RESET BUTTON IN THE CONTROL BOARD OR ON THE CONTROL BOARD

You have a bad main control board if u push any button it’s just flashing u need to replace main board located on back side of the fridge

Firstly open the back of the refrigerator's back and check the refrigerator evaporator to excess the fan if there is fan cover present remove it with the screwdrivers. Then unplug the fan from the refrigerator with the help of tools like screwdrivers, and 1 thing to keep in mind to remove all the connections before removing.

some shelves glass lift out the others dont

I seem to be having the same issue with a Maytag refrigerator model M1TXEGMYS01. I would like to thoroughly clean all shelves of this new-to-is refrigerator but I can’t seem to figure out how to remove the glass from the plastic housing. I was able to take the end and central brackets off (that hold the drawers) but I can’t figure the rest of it out... and the manual I looked up didn’t provide any information on separating the housing either. Please see pic attached. Thanks in advance!

Unfortunately this is not an issue that can just be reset. No real troubleshooting is needed based on your symptoms . unfortunately this is a well known problem for this particular refrigerator and you won't see any signs of failure but the problem is the high voltage control board on the back of the refrigerator behind the 8? x 8? access panel. if you pull the refrigerator out, there is a panel on the back and if you remove it that board behind that panel test it but most likely needs to be replaced.

look for error code --beeping can be anything from open door to unit failure

Fridge keeps beepingor buzzing:The following is for Frigidairemodels but others can be addressed similarly. Several Frigidaire refrigerator models have an electronic control panel on the freezer door the owner can use to adjust the internal temperature, dispense ice and water and receive notification about issues such as the need to replace a water filter. The refrigerators also emit a beep for various actions and as an occasional alarm. Determining what causes the beeps necessitates some troubleshooting. Temperature Controls

• A Frigidaire refrigerator's display panel blinks when the control panel is touched to set temperature controls. After pressing "Freezer Temp" or "Refrigerator Temp" on the keypad, press the arrow buttons within five seconds to increase or decrease the desired temperature. If you do not press the arrow buttons within five seconds after pressing "Freezer Temp" or "Refrigerator Temp" on the keypad, the refrigerator beeps to indicate the current setting will stay in place.

Door Open

• When you leave the refrigerator or freezer door open, the refrigerator beeps. Also, the "Door Ajar" indicator illuminates on the appliance's display panel. Shutting the door and pressing "Alarm Reset" stops the beeping and turns off the "Door Ajar" indicator light.
• The Frigidaire refrigerator has a control lock feature that prevents use of its control panel or dispensers when the unit is locked. When the control lock is active, a beep sounds when a keypad or dispenser is pressed. Release the control lock by pressing the "Control Lock" icon for three seconds. A beep will sound, and the icon's light will go out.

Power Reset

• A power reset is occasionally necessary if the Frigidaire refrigerator's control panel does not work normally or a reset function on the keypad does not work. A power reset involves disconnecting power to the refrigerator by unplugging its power cord from the electrical outlet, waiting 30 seconds and plugging the power cord back into the electrical outlet. When the control panel resets, a beep sounds. If the refrigerator beeps even after a power reset and the beeps' source is not known, contact Frigidaire.

Read more : http://www.ehow.com/info_12148688_cause-beeping-noise-frigidaire-refrigerator. http://www.appliancerepair.net/refrigerator-repair-1.html

There are 2 power supply filter caps that appear to go bad and the result is the blinking and flapping