20 Most Recent
Palm Z22 Handheld - Page 3 Questions & Answers
After charging, the palm does
Page 20 on the following Palm Manual explains performing a soft and hard reset, to try to get it working:
http://www.palm.com/us/support/handbooks/z22/en/z22_ug.pdf
I'm not familiar with the contacts on this device, but if there are any inside the device, and the battery isn't hard-wired, clean the battery contacts on the battery and inside the camera with a qtip and alcohol, or a pencil eraser.
Make sure the charger voltage is good (measure it with a voltmeter), and measure the battery to make sure it's holding a good charge). If it isn't, get a replacement.
Good luck, and hope this helps.
5/28/2011 9:05:05 PM •
Palm Z22...
•
Answered
on May 28, 2011
I have a Z22 Handheld which is exhibiting some
Hi,
Yes you can, but before you that, let see if the problem of the Z22 can be attended to, power it off, after a while power it on back, while it is loading or booting, remove the battery and wait for minutes before putting it back, put back the battery and see how it works.
5/13/2011 1:25:19 PM •
Palm Z22...
•
Answered
on May 13, 2011
I updated my skype, i
Skype 5.0 requires an intel processor and Leopard (10.5.8) or newer OS. You cannot run it on a G4. Discard the application and find an older copy (2.8) (possibly from a backup since it doesn't appear to be available at Skype.com).
3/15/2011 7:10:53 PM •
Palm Z22...
•
Answered
on Mar 15, 2011
Touchscreen and/or stylus are not working
You need to take the Palm z22 apart. Use your finger nail to pry off the small cover that surrounds the UBS connecter. Then unscrew the two screws you see. Now Stick your finernail into the middle side of the Palm. Where the white tope meets the black back cover. Use a very small screwdriver to go into the space you made with your fingernail, and pop the plastic holders. You can see where the clips are by looking at the side.Careful not to break anything.
Now your palm is open. The touch screen connector needs to be removed and put back in. Remove the plastic retainer, pull out the mulit cord ribbon, put it back in, put back the retainer.
Next move the black plastic foam that is on top of the retainer clip. I think when you close the case it squeezes the retainer in a bad way.
Put everything back together. If your scrared to try it send me your palm with some stamps for return postage and I will try it for you.
3/14/2011 12:09:52 PM •
Palm Z22...
•
Answered
on Mar 14, 2011
I recharge my palm zire
1. Go to Home Screen.
2. Select Prefs.
3. Select Power.
4. Select Auto -off after 30 seconds(1 minutes, 2 minutes or 3 minutes, whatever you want)
Hopefully this answers your question.
or there is a Power button on left side of device. Make sure the device is unlocked and press Power button.
3/2/2011 6:28:50 PM •
Palm Z22...
•
Answered
on Mar 02, 2011
Palm cannot connect with the desktop, error modern
Hello Issamai
1. Ensure that your willing to consider pairing your phone with your PC in bluetooth mode 2. If so, please proceed 3. Place both your computer and telephone in bluetooth discovery mode 4. Setup up bluetooth simple password such as 12345 5. Accept the incoming connection on both devices and start to transfer your information this way 6. Understand that most cell phones have built in device drivers to allow for easy linking when attempting to connect your phone straight into your PC. 7. When the technological market invented bluetooth, and sim cards, many cell phone carriers NO LONGER place a large importance with direct linking. 8. You may always share an internet connection between your cell phone and your computer by using bluetooth technology. (Very reliable and cost efficient). 9. If you need a bluetooth adapter for your pc, you may always purchase one off the internet for a few dollars. 10.Please advise on how I may continue assisting you so we MAY RESOLVE YOUR PROBLEM THE FIRST TIME AROUND.
Thank you for allowing
us to help, please respond with further questions and concerns
Spanish speaking
available for all problems
Before you leave
feedback, ensure that your concerns and problems are addressed completely with
me.
PLEASE do not forget to
award/PROVIDE "POSITIVE" FEEDBACK
Hello, thank you for
sharing your problem with us, I would personally be happy to provide the most
accurate and up to date information for you.
1/10/2011 7:52:09 PM •
Palm Z22...
•
Answered
on Jan 10, 2011
I am very happy with
There are various ways to sync your datebook and other information to your desktop. the following links illustrate a couple of ideas:
- http://www.ehow.com/how_2042596_synchronize-outlook-palm-pilot-z22.html
- http://www.ehow.com/how_6183676_sync-palm-z22-outlook.html
Hope this solution has been helpful?
12/16/2010 5:56:08 PM •
Palm Z22...
•
Answered
on Dec 16, 2010
No driver for Z22 compatible with Windows 7
windows 7 is new and not compatible with many software so you may not get to sync your palm Z22 by using windows 7. You need a model that is compatible with windows 7.
11/5/2010 7:48:54 AM •
Palm Z22...
•
Answered
on Nov 05, 2010
I have a palm zire72 and I changed the battery but
when you press the buttons do you get sounds?
if so, it is probably the cable for the screen!
I am not an expert on this, but make sure that all connects are firmly joined.
And if you are pushing a cable in DO IT GENTLY or you might brake it!
10/30/2010 10:52:30 AM •
Palm Z22...
•
Answered
on Oct 30, 2010
Not finding what you are looking for?