20 Most Recent Samsung LE32R41BD 32 in. HD-Ready LCD Television - Page 8 Questions & Answers

Settings:
-Picture menu
Mode: Movie
Backlight: 1
Contrast: 93
Brightness: 54
Sharpness: 0
Color: 45
Tint: 50/50

Hi.

If the tv set is still under warantee get it sorted before gtee runs out.

The problem is caused by cummunication error between ATV Micom and DTV Micom.

To correct this problem requires going in to service mode to make changes & updating the DTV firmware.

This will need to be done by a proffesional.

http://dysonmanuals.llc.nu/

Chris.

i rang the shop i brought it from it was cheaper than yuor offer

I'm having the same issue. I'll be watching the television an all the sudden the screen goes black/turns off. I turn it off and back on again and picture comes back on. It doesnt seem to have any consistency..

no sound via pc

its definately the problem of the convergence ic in your tv.

in order for me to help you and answer your questions explain to me exactly what happened up to this problem and what exactly happened ok.

could be a loose LVDS cable, if not it is the lcd panel

I can switch between shop mode & normal by holding down the menu key on the side of the screen, just press it till it changes.

SHAME

It either has a sticking switch (usually caused by using cleaning solutions on the screen) or the power relay is faulty or the remote control is faulty.
Take the batteries out to check the remote.
Thanks guy9

replace the power supply

Dynamic mode will give you a brighter picture. The energy saving mode runs the lamp at a more efficient level that saves energy at the cost of a slightly darker picture. Based upon your description, I'd guess that the lamp is nearing the end of its useful life. Plan on changing the lamp soon. When you do so, place the set back to standard mode and energy saving.
Dan

Attention, noisy pictures on dynamic image does not mean to change the main board, most of the time , the panel need to be replaced, not the main board.

Could be a main board.Tuner could be bad.

My daughter's LCD which is barely used started showing horizontal coloured lines.I read that the LCD's are vunerable to static/charge build up and also power surges.

I unplugged my daughter's TV and it is now working properly however we now unplug the TV when it's not in use.

I was considering purchasing a larger model for the faily room but Not going to waste my money until they improve this rechnology.

Good luck to all.

Cheers!

Plug the TV into a wall socket by itself, have seen this when TV was plugged into a power strip.

need more info such as do you still have audio? Is the LED on the front still lit? can you see any back light ?