20 Most Recent Siemens SpeedStream 4200 (13A4200001) Bridge - Page 6 Questions & Answers

hi Fip,

Here is a link, Step by step!

http://www.siemens.com/index.jsp?sdc_p=ft4mlsuo1274280n1274280i1272700pc9z2

Good Luck!

Two things:

1) Is your phone bill paid?
2) Have you installed filters on the phone line and data line?
3) as you said, check for anything sticky on the speedstream itself, something might have been spilled, or even water for that matter.

if you are using bittorrent client then

block the ports 6881 to 6889

I use knoppix v3.3 (linux) to test a hardware part (1cd only, not the latest, but the fastest) boot from cd.
http://www.knoppix.org/

Test your system with that first.

Thats just a half part of the problem, but after that you have only 50% left. (I am not a linux expert, but I can use that CD easy)

Hi kellysdad,

Setting up static IP is what we called manually IP or not generated by DHCP. Maybe you where putting the same IP between your bridge and your network TCP/IP properties.

Try to removed your network devices from hardware control panel and installed it again..

Hope this will be helpful to you.


Best Regards,


Philip

put the modem in bridge mode and then connect a DSL/cable router to it...you'll have to configure the PPOE if its DSL... Cable is a little easier because there usually is a MAC authientication not username and password...plug dsl/cable router into cable modem...turn both off for about aminute then turn modem on first then router... Be careful most routers with wireless have it enable with no security by default...turn it off or set securty (wirelss that is)

Use the meter to read for an hour and then for a day.

Digital Energy Monitor - Electrical, Series 1000 / 2000 ...

Siemens https://sid.siemens.com > ... Digital Energy Monitor - Electrical, Series 1000 / 2000 Technical Specification Sheet - Data Sheet for Product. 44908_en.pdf. Product Family: APOGEE; Product ...

Digital Energy Monitor - Electrical, Series 1000 / 2000 ...

Siemens https://sid.siemens.com > ... 538-986_Digital Energy Monitor - Electrical, Series 1000 / 2000 Installation Instructions.

The start button has quit working and will need to be replaced.

You must factory restor siemens simatic to remove password. Or flash it will custom rom as per your siemens model.

Look on u tube they might have one