Top 20
Hitachi Travelstar 5K100 HTS541060G9SA00 60GB 5400rpm 150MBps Serial ATA Serial ATA/150 I... (0A26923FT) Hard Drive Questions & Answers
How to get master password for hitachi hard drive
Wow, why don't you know the password? I'm not calling you a thief, but 99% of the time when you encounter a computer that has a lock on the hard drive and the person in possession of the computer does not know the password, the computer is stolen. The original owner puts a lock on it to keep thieves from getting to sensitive data.
6/2/2012 5:45:34 AM •
Hitachi...
•
3,315 views • 0 helpful votes
I have a HITACHI TRAVELSTAR
If they can recover data, they will can repair too taht hdd, if they not know how, say them with Live CD Hiren's boot, in there 2 program realy working for rapairing, MHDD, and in Hdd tools\ TEST AND REPAIR HDD
6/3/2011 7:24:29 PM •
Hitachi...
•
436 views • 1 helpful votes
How to download the driver
I am not familiar with Linux but have you checked your Bios to see if Sata Hard Drive is recognized in there??? Most of the time you have to set the bios to recognize a Sata drive because 90% of Hard Drives are still IDE and most bios software is still recognizing the IDE drives. I know I had to reset everything on my Motherboard and Bios when I changed over from an IDE to SATA Hard Drive.
11/1/2010 4:03:27 AM •
Hitachi...
•
1,256 views • 1 helpful votes
My computer has no problem
During the boot process you will see on the screen to press a certain key to enter setup
Press and hold that key during the boot up process to enter BIOS the scroll down to advanced bios features press enter change your first boot device to cd,press escape then press f10 to save to cmos to restart
(note after you have loaded the operating system you must go back and change the first boot device to your hard drive)
The BIOS is AMI. Under ADVANCED SETUP:
The options listed for 1st,2nd ,3rd Boot device include:
IDE-0 means Pri master ?
IDE-1 means Pri slave ?
IDE-2 means Sec master ?
IDE-3 means Sec slave ?
?
The BIOS is AMI. Under ADVANCED SETUP:
The options listed for 1st,2nd ,3rd Boot device include:
IDE-0 means Pri master ?
IDE-1 means Pri slave ?
IDE-2 means Sec master ?
IDE-3 means Sec slave ?
?
? single or master :::::
master with slave ::'::
???????????????? slave? :::':
note the plastic jumper is ' located at the rear of the hard drive next to the IDE/SATA lead/s
?
One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect your hard drive
Test all leads that attach to your hard drive including electrical extensions,IDE,SATA
the leads from your motherboard to your hard drive make sure they have a secure connection and are not faulty or just replace them there probably old and faulty
?
hope this helps
12/12/2010 11:49:33 PM •
Hitachi...
•
147 views • 0 helpful votes
When I connect USB it system detects the hard drive but could not
Try it on another computer and see if you can open it up there. If it's still showing as 0 bytes then it's obviously a problem with the usb drive.
If it's a thumb drive (or some other solid state storage) then you're probably going to have to look into a data recovery service as they're going to have to remove the memory chips to access the information.
If it's an external case with a hard drive inside it then the best bet would be to open up the case and pull the drive out. Try connecting the drive to a computer (make sure the computer is off, then turn on) that way or through another external case. Be careful though, if the drive is making any funny noises or clicks then you could be damaging it and you'll need to again, take it somewhere for data recovery, also if the drive is not spinning at all (it's easy to tell) then you'll have to take it in. There's a chance it'll work fine though and your external might just be bad
3/2/2010 7:27:56 PM •
Hitachi...
•
180 views • 0 helpful votes
Dell Inspiron E1505 won't boot
Try this site to look for hard drives. Not just any drive will work, so make sure you confirm with the company's sales or tech support to make sure it'll work.
LINK
12/11/2008 5:36:52 PM •
Hitachi...
•
355 views • 0 helpful votes
My burner is not working
This sounds to me like your CD/DVD is borked,& you need a new one, sorry.. Ya see, really the only way ya can "see" if it is OK, or not, is to try another one... to isolate the problem.
They break down quite commonly I have found.
If you are unable to do this, then it's off to the repair shop.. As I always say in these cases get a firm "Quote" and an explanation of repair.
9/1/2007 4:12:52 AM •
Hitachi...
•
85 views • 0 helpful votes
Where can i find drivers for travelsrar 5k500 b-250
Click start control panel administration tools computer management device manager scroll through all of your devices If you see a yellow question or exclamation mark ? ! or a red X you will need to update the drivers for this device right click select update driver/reinstall driver if you can see your usb device but its not working scroll to Ports(Com&Ltd) right click to update driver If you computer came with a motherboard disk the drivers could be on it.
Rather doing a driver hunt which can take hours http://download.cnet.com/slimdrivers-free/3000-18513_4-75279940.html Windows XP/Vista/7/8 it might take some time being a freeware driver solution Note: it will find all of your outdated drivers This will automatically search for and find the correct driver you will have to update every driver individually once you update you might be asked whether you want to restart or make a system restore point. Click no to both of these then continue updating each driver free then restart once all of the drivers have been updated. Hope this helps.
1/10/2013 10:04:16 AM •
Hitachi...
•
849 views • 0 helpful votes
My Hitachi XL500 external hard drive is not showing anywhere on my computer. I also do not believe any power is getting through to my hard drive. Please help
buried in endless spam are you.
does it fail on 2nd PC????????????????????????????
but yes, I am the MVP of external HDD< I build my own.
Have over 5 here for Backups .
lots of causes, for sure bad drive, or missing drivers..
bad HW hardware or BAD software SW.
Missing 12vdc 2amp power pack>, lost or using wrong one.
when pack above does the HDD spin? usb connected to PC.
NO PC stated, NO OS stated, windows/chrome/Linux/android?
its at lease 10 years old , see posts back that far.
not good old HDD,this old.
sold during W7 era. 2009.
The drive has 3.5" HDD that needs lots of power (Amps)
to start up that big motor inside, and is first thing to learn .
2amps it needs, ok? so if pack is missing it will never startup
on any USB port, not rated for 20x standard USB load factors.
some laptops only do 0.1amps (100mA) and are useless to startup any hdd motor of any kind.
see why here.
and see a better extremal solution cheap.! $10
http://www.pcdied.com/external-hdd.html
7/3/2019 10:33:42 AM •
Hitachi...
•
522 views • 0 helpful votes
Not finding what you are looking for?
