20 Most Recent Janome Memory Craft 9500 Computerized Sewing Machine - Page 2 Questions & Answers

You download onto PC the upgrade from Janome. Copy this to the card for reader on your machine. switch machine on and go to section on screen for card reader Insert card into reader. instructions should appear for downloading onto machine. Hope this helps and is not too late

when your machine on your machine movable arm pushing a switch liver which will raise your feed dogs you can do one thing when your arm moves to the normal possision just given your finger to the upside movable are you see one long switch bar is there just push and see machine feed dogs will come out actualy that action to be done by arm only,you call one MC expart to resoved your problem permenetly.

You can never used oil to any MC machine. it will damaged the sensore of your machine.If possible just open head cover and clean broken thread from the movable part.

Your machine one sensore may be damaged. call expart person for repairing your machine.

Put your card and select touch screen embroidery mood then you can see the designs. Design should be loaded to the card through customizer and CF card size to 1GB or less.

# Insert your memory card into your computer's reader if you have one. If not, you can purchase a multi-format USB Memory Card reader from Amazon.com or Buy.com
# 2 Open up 'My Computer'. You should see it under the list of available drives.
# 3 Check its contents first to make sure that you have the right drive.
# 4 In 'My Computer', right-click on the drive and choose 'Format'.
# 5 Leave all the options as they are and click on 'Start'. This is a non-reversible process so make sure this is what you truly wanted to do in the first place.
# 6 Once the process is completed, take the memory card out and insert it into your Digital Camera or any other device. Try to browse to it to make sure it works fine now.

it sounds like the machine needs to be checked for a adjustment at a sewing machine shop.

I too have just purchased a new machine and had same problem.  You have to put the card in your sewing machine first to format it.  My machine is a Janome 10001 but think it is the same concept.  When I save a design from the internet to the card I have to drag the design into one of the Emb folders which will show up on your card after it is formatted.  Then after saving the design I can go back to the Emb folder that I saved it in and it will show up on the machine.  Hope this helps.

Loose on bottom is usually caused by too loose tension on top thread, check top tension and thread is in the tension device.

Who told you that you needed a pc board? your neighbor.. or your Janome Tech? It may be a known issue... check with janome hotline.

check with a janome dealer

Check and make sure your bobbin is unspooling in the correct direction.

Please see PDF Page 102 of this online manual. http://content.janome.com/documents/File/ManualFile/Inst%20book%20MC9500%20%28En%29.pdf

the tension dial may have went out & need to be checked at a sewing machine shop

check with janome for a manualor sewingpartsonline.comsewusa.comsew4less.comsewvacdoctor.coma1sewingmachines.comyoutube for a video

the machine needs to be check to see if it's a tension problem or timing