20 Most Recent Riccar R650 - Page 3 Questions & Answers

https://www.sewingpartsonline.com/instruction-manual-riccar-805.aspx

Usually, the looper separation is permanently set. You can change the length but not the width of the stitch. You can also change the distance the stitches are from the edge of the fabric.

Here's the manual for your machine. Download and keep it because you will probably be needing more in the future. RICCAR 9900 Instruction Manual

To found this in a storage unit and don't know very much about it but it works just fine. There is no visible damage. Comes with plastic cover. AC Service Cheapest Aircon Cleaning Servicing Singapore Air Conditioning...

https://www.manualslib.com/manual/140654/Riccar-Rl634de.html Riccar RL634DE User Manual

Sounds like it's shorting. out. Be careful, unplug it before you check the pedal for loose wires etc.

Where could I get a back looper for a Riccar rl-924dr

Page 61 of the manual: RICCAR R651 Instruction Manual Page 61

Increase the top tension. It should pull up the bobbin thread into the fabric.

Sorry to say, but usually misthreading is the culprit. The machine must be threaded "each thread" in the correct order (usually upper looper first, then lower looper) and following the correct threadpath. Also, the presser foot should ALWAYS be raised when threading. Give each thread an extra little tug (grasp thread below the thread tree and also below the tension disk) to make sure it seats completely.

RICCAR R950 Instruction Book Riccar sewing machine manuals Sewing machine Riccar Super Stretch 505 Even if it's not your model machine, the threading instructions and basic use would be similar.

Looking at the pictures, I would say, "No." Riccar 808e sewing machine Spinninglizzy Weblog Even if the table would fit both free arms, it is likely the attachment mechanisms are different. ...

Um, you can try searching for: Make Model parts diagram Otherwise, $100 for a service call on a sewing machine is pretty standard. If you haven't had your machine serviced in quite a while, it may be a good time to bite the bullet and get it cleaned, oiled, and adjusted and also repaired by a professional.

Search the internet for: Manufacturer + Model ...

Perhaps the manual would be helpful: RICCAR RL343DR Instruction Book Page 14It appears that you need to install a hemming foot.=================It is not easy but it is very similar to stitching a blind hem on a sewing machine--except you will also have to be careful that the knives do not cut the fabric. It can be done, but some practice would be good before trying it on a garment. The skill is stitching on the very edge of the fabric without getting it into the knives. If you were to disable the cutting knives on your serger, you could very easily break a looper or knock the machine out of time because the knives prevent the fabric from extending into the looper action.Here are some videos (more available online):https://www.youtube.com/watch?v=WdwlJmfm...https://www.youtube.com/watch?v=LCMIXOGH...A coverstitch machine would stitch a hem such as what you want, but that's because it does not trim the fabric--it basically is like using a twin needle in a sewing machine.