Top 20 LG LSC183VMA Split System Air Conditioner Questions & Answers

Compressor lock out means the compressor is bad and would need to be replaced

Hi sir we have super general mounted split ac e6

Switch the power off for 60 seconds and turn back on, also remove the battery from remote if you have one and replace

what is E2 error

E6 error code comes for room sensor in this. It means there is any damage in sensor. Pls replace it

C5 error blue star air condition

Supply fan motor is either shot or needs to be cleaned. Generally if the whole wall is shaking there is a bearing out on the motor. I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_54ae41aaaffbab00

WHICH GAS IS REQ FOR INVERTER LG AC

You must replace the pc board of the outdoor unit.

could not find the error code but I did find a manual, hope it helps Tim:

http://webshop.bauer-energi.no/PDF/Service%20Manual%20N12AWV_N09AWV.PDF

Inverter compressor run current high. Check compressor windings all equal 1 to 4 OhmsCheck to earth 50 MOhm minimum, check run current. If high, winding is weak. Solution: Replace compressor.

Friend!,
Please ensure with your model/brand and error code. To my knowledge and web search, I don't find tour model on market. Don't be angry, plz check once again and write back.

Hi, this error is a communication error between your indoor and outdoor unit, check all wiring and connections - ch 5 is a communication error between the indoor unit and the outdoor unit. You can try turning the breaker off for a few minutes and restart the unit. However if that does not work its best suggested to have an authorized HVAC technician service the unit.

CH-05 Communications Error, check your wiring, remove external pumps. Split/Multi - check volts from terminal N to 3 = 0 - 65 Vdc, Multi V - 4 Vdc terminals 3 and 4

Il mio condinoziatore LG segnala CH 05 cosa vuol dire

i am air con tech and i face all ready this problem may be it will help u . e5 error is ur air con not have gas becoze of that the low presser switch give error on disply thanks best regard for all. pls let now if its help full

According to the service manuals:

6 is:
Excessive current at inverter
DC power circuit

so the unit shouldnt run?!?

The fault is also coming up as:
indoor unit coil sensor faulty

source:
http://www.mylg.co.uk/data%20for%20site/LG%20Fault%20Codes%20for%20SMS%20%2807%20Sept%29.pdf

all the best