20 Most Recent
Polaroid FLM-2632 Television - Page 6 Questions & Answers
Polaroid FLM-3228
cheak cables gold leads only hi end ground antenna good power strips get any magnets stuff away from it interfence ok
2/12/2008 1:11:29 AM •
Polaroid...
•
Answered
on Feb 12, 2008
Buzz from back of the tv
It is likely that one of the transfomers is buzzing due to heat and laminations or wire is ringing.
It should not cause any issue except annoy you. it must be replaced. or
glued back down which is usually very difficult as they are wrapped
and/or sealed.
Only way to find out is to open the unit and trace it down.
If it is dust buildup then you should be hearing a crackling. zzzztt sound.
1/31/2008 6:52:00 PM •
Polaroid...
•
Answered
on Jan 31, 2008
Picture is not stable
Check the Power Supply board to see any puffed capacitors. If found faulty cap, replace them.
1/5/2008 2:08:42 PM •
Polaroid...
•
Answered
on Jan 05, 2008
Nosignal
you need an outdoor antennae or a cable conection. Mke shure that your connecting cables are in good condition. also check the ("F" fitting, that is the end of the cable that screws on to the back of the tv, sometimes the center wire gets bent and it dosen go into the center conection.
Lou Margo
Allied Electronics
[email protected]
12/7/2007 10:03:08 PM •
Polaroid...
•
Answered
on Dec 07, 2007
Ratio
Does the sky box have a setting for output ratio?
If so try adjusting it and see what the TV does.
6/10/2007 1:05:31 PM •
Polaroid...
•
Answered
on Jun 10, 2007
VGA input
is your laptop capable of sending widescreen video to your TV or can it only send 4:3 video?
5/26/2007 6:24:49 PM •
Polaroid...
•
Answered
on May 26, 2007
Remote
The manual for this TV can be found on this page: http://www.polaroid.com/service/userguides/ce/ce_ug.html
The specific pdf for the FLM 2632 is here:
http://www.polaroid.com/service/userguides/ce/lcd_tvs/flm_series_ug.pdf
5/11/2007 5:24:21 PM •
Polaroid...
•
Answered
on May 11, 2007
Problem with my flat screen polaroid
Check all your connections if they are connected properly.if connections are good that means the tv is having problems in the color circuit call a tech to do repairs on your tv.good luck.
4/14/2007 2:07:20 AM •
Polaroid...
•
Answered
on Apr 14, 2007
Polaroid TV working with constant red flashing light
If your Polaroid Roku TV is working fine but the red light is continuously flashing, it could indicate an issue that may need attention. Here are some steps you can try to troubleshoot the problem:
- Power Cycle:
- Turn off the TV and unplug it from the power source.
- Wait for at least 5 minutes.
- Plug the TV back in and turn it on.
- Check Remote Control:
- Ensure that there are no stuck buttons on the remote control. Press each button to make sure they are not stuck in the pressed position.
- Update Firmware:
- Check if there is a firmware update available for your TV. You can usually find this information in the TV's settings menu.
- Reset to Factory Settings:
- Perform a factory reset on your TV. This will erase your settings, so be sure to back up any important information first.
- Check for Physical Obstructions:
- Make sure there are no physical obstructions around the TV, particularly around the infrared sensor on the TV and the remote control.
- Contact Customer Support:
- If the issue persists and your TV is still under warranty, consider contacting Polaroid customer support for assistance. They may be able to provide additional troubleshooting steps or offer a solution.
- Professional Repair:
- If the TV is no longer under warranty and the issue persists, it might be advisable to consult a professional technician or a TV repair service to diagnose and fix the problem.
Always refer to your TV's user manual for specific instructions related to your model. If none of the above steps resolve the issue, it's recommended to seek assistance from the manufacturer or a qualified technician for further diagnosis and repair.
12/27/2023 10:15:57 PM •
Polaroid...
•
Answered
on Dec 27, 2023
Not finding what you are looking for?