20 Most Recent Frigidaire ATF6000ES Front Load Washer - Page 2 Questions & Answers

-Have you try to "Drain and spin " cycle to finished its cycle's program ? If not then try it. Good luck Mai

It sounds like the pump has stopped and may have sucked a sock or rag into it. May need to pull the washer out, remove the back. Unplug the washer and see if you can manually turn the pump/motor belt. It could also be the motor but I would check to see if they turn. If not, remove the belt and manually try to turn each and see if they turn.

Sounds like you got a broken drum spider usually due to overloading. And that's a major break down quite expensive but can be done.

Did you try pouring some white vinegar into it a few times? This may work. God-Bless! you might have to do this a few times, And let it sit for a bit.

the most common cause is worn out brushes in the motor, sme brands you can rplace the brushes others require a new complete motor

yes the water vale is defective it has goten a little piece of sand of something in it and it dont take much replace the valve and the problem will be gone good luck

you need a bearing puller to remove the pulley, huck the 3 lips on the outer of the pulley hub and tighten the bolt on the puller but not to fast nice and slowly and it will come off.