20 Most Recent Frigidaire FAP094P1Z Portable Air Conditioner - Page 6 Questions & Answers

I didn't think portable acs have tstats. What's the model number? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

unplug it if you can and let it set for 20 minutes, set the temp control where you want it and plug it in, wait a bit and see if it starts cooling. you can confuse these things if you turn it off and on rapidly or change the temp control up and down sporadically. The compressor has to take it's time to kick on after it has been shut off and then on again.

This unit is a 220 volt ac unit. 12-2 wiring is usually for 120 violt circuits?

Amps: 22.2 / 20.0

Watts (Heat): 4900 / 4000

Watts (Cool): 1650 / 1625

Amps (Cool): 7.7 / 8.3

Voltage Rating: 230V / 208V 60Hz

Power Cord Length: 5' (6')

Horsepower (Cool): 2.49

Plug Type: LCDI 6-30P

http://www.frigidaire.com/Home-Comfort/Air-Conditioning/Window-Mounted-AC/FFRH1822R2 hope this helps?

Sounds like a high pressure fault. Is the outdoor fan running? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Sounds as if your blower wheel is damaged or the balance weight has dislodged. Turn power off and inspect blower wheel. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

It SHOULD NOT ... (smell in... even in WEST TEXAS). BRAND NEW... Rush on down and get a good NEW one. I would suspect the condensate drip pan is plugged... Common for AC units .. But NEVER in "brand new"... Get that (previously owned (my opinion)) UNIT back from where you bought it ... Trade it in for a CLOSED BOX... and make your sales CLOWN write up why you are returning it. Mold can be quite dangerous!! Carnac the Magnificent

If the blower is not running its likely not setup properly on the tstat. Be sure its setup for electric heat with forced air. Tstat controls the fan If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Can't find E5 but ES is a probable faulty evaporator sensor fault. Check the wireing for any damage or loose conections and if all is ok thenyou will have oreplace the sensor. Hope this helps

Make sure you have power to the unit by plugging something else into the plug

You have to try resetting the system. First turn the breaker off for the condenser and wait about 20 seconds. After you turn it back on the system should reset. If you are having prolonged air conditioning check out Air Conditioning Tamarac for more HVAC Support.

Is this a window unit?