Top 20
Whirlpool 24 in. GU2500XTPS Stainless Steel Built-in Dishwasher Questions & Answers
Clean light blinking will not start
If the clean light flashes 7 times, pauses, then repeats...
When
the dishwasher doesn't sense a water temperature increase, it stops
working and locks the functions (clean light flashes 7 times, all
buttons are non responsive). It does this as a safety in case the
element is broken and feeding electrical current into the water.
To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...
-high temp wash
-heated dry
-high temp wash
-heated dry
...all
the lights will turn on briefly and the machine will start a diagnostic
cycle. Let it go through the diagnostic to test the function of the element.(1-2 minutes). When it finishes, open the door and touch the element to see if it is hot (be careful, it can get pretty hot so wet your fingers to avoid burns).
Once the diagnostic has cleared, you should be able to run the dishwasher as normal.
If
the issue returns, you could have a problem with the heating circuit
(ie. element, thermostat or wiring).
It rarely happens but it could
also be the door switch not engaging properly when the door is closed
(slightly bend the door latch down making sure it doesn't hit the door
when you close it).
Good luck!
Wonderful Whirlpool Washus Interuptus!
My plan was to see if I could find you a service manual, but strangely, the only reference to that model number is your post here! My guess is the D6 is 'D for Dishwasher' and 'Series 6' or 6 models in that current series.
If the machine has been laid up or little used, check all the connection on the control board. Clean pins and plugs with electrical switch cleaner
https://www.google.com/search?q=DU940QWD6
..
7/27/2023 6:52:47 PM •
Whirlpool...
•
48 views • 0 helpful votes
How would I get access to whirlpool dishwasher pump?
Miniplayer (i)
We'll also want to shut off the inlet watersupply and disconnect that as well.
0:30/8:42
Please refer to youtube " Whirlpool Dishwasher Repair - How to Replace the Pump (Whirlpool # W11032770) "
3/22/2023 8:29:06 AM •
Whirlpool...
•
51 views • 0 helpful votes
My whirlpool dishwasher model # WDT780SAEM1 makes a loud popping noise when I open and shut the door. What is causing it and how do I fix it?
The loud popping noise that you're hearing when you open and shut the door of your Whirlpool dishwasher (model # WDT780SAEM1) is most likely caused by the door gasket. The door gasket is the rubber seal that runs around the door, creating a tight seal when the door is closed.
Here are a few things you can try to fix the issue:
- Check the gasket for damage: Inspect the door gasket for any tears, cracks, or other damage. If you find any damage, you will need to replace the gasket.
- Clean the gasket: Over time, debris and food particles can accumulate on the gasket, causing it to become stiff and not seal properly. Clean the gasket with a mild detergent and warm water, and then dry it thoroughly.
- Check the door alignment: Make sure that the door is properly aligned and not hitting the gasket when you open and shut it. If the door is not aligned properly, you will need to adjust it.
- Lubricate the hinge: If the door gasket is in good condition and properly aligned, the problem may be with the hinge. Try lubricating the hinge with a silicone-based lubricant, as this can help to reduce friction and noise.
- Contact Whirlpool: If you have tried all of the above steps and are still unable to fix the issue, contact Whirlpool customer service for further assistance. They will be able to provide you with additional troubleshooting steps or advice, or they may need to send a technician to repair or replace the dishwasher.
It's important to note that if the popping noise you're hearing is accompanied by other symptoms, such as leaks, then it may be related to a different problem, and you should contact Whirlpool customer service or a professional service technician for further diagnosis and repair.
1/9/2023 6:26:59 PM •
Whirlpool...
•
72 views • 0 helpful votes
Whirlpool gold quiet partner iii soak and scour indicator light on won't start
Es posible que la luz Soak & Clean del lavavajillas Whirlpool Gold Quiet Partner III no se encienda si el lavavajillas no est? recibiendo energ?a o si el lavavajillas no est? en el ciclo correcto. Se recomienda verificar la fuente de alimentaci?n y asegurarse de que el lavavajillas est? enchufado y reciba energ?a. Si la alimentaci?n est? conectada y el lavavajillas est? en el ciclo correcto, entonces es posible que haya un problema con los circuitos o el cableado del lavavajillas. Se recomienda ponerse en contacto con un centro de servicio autorizado de Whirlpool para obtener m?s ayuda.
1/6/2023 2:05:27 AM •
Whirlpool...
•
61 views • 0 helpful votes
Updated question - What would cause a Whirlpool Dishwasher DU1148XTPB3 Soap Dispenser's trigger/spring to continuously try to open the soap dispenser after it has been opened.
here are a few possible causes for a dishwasher soap dispenser's trigger/spring to continuously try to open the dispenser after it has been opened:
The trigger/spring mechanism may be damaged or broken. This could be caused by normal wear and tear over time, or it could be the result of a foreign object getting stuck in the mechanism.
The dishwasher's control board may be malfunctioning. If the control board is not functioning properly, it could send a signal to the soap dispenser to continuously open and close.
There may be a problem with the dishwasher's timer or motor. If the timer or motor is not working properly, it could cause the soap dispenser to malfunction.
To troubleshoot the problem, you could try cleaning the soap dispenser and checking for any foreign objects that may be stuck in the mechanism. You could also try resetting the dishwasher by turning off the power and unplugging it for a few minutes, then plugging it back in and turning it on. If these steps do not resolve the issue, it may be necessary to call a professional for further assistance or to consider replacing the soap dispenser.
12/29/2022 3:03:38 PM •
Whirlpool...
•
50 views • 0 helpful votes
Not finding what you are looking for?