20 Most Recent Candy AQ130 Front Load Washer - Page 6 Questions & Answers

You will need to replace the control panel.

have you checked the cold water solenoid ?

keeps flashing even if u pressed it ? go back to off position . wait 10 seconds , open the door , close it . select again .

It could be clogged or bad pomp

If I read your words correctly, when you turn on the washing machine it immediately causes a fuse to blow out or a circuit breaker to flip off. If this is so, please do NOT turn this machine on again until the problem is repaired with your washing machine, or you may start a fire in your house or apartment you will be unable to put out. I am guessing you have a short in either the motor or the control panel. God bless your efforts.

Usually these filters are mostly similar style. Try gripping the middle plastic ridge bar and turn it counter clockwise. They usually have a nylon spigot thread at the back which unscrews(be aware that water trapped will flow out front seal as it is unscrewed. Good luck!

yes you can unplug the machine take the back off and look for a small 5mm pipe leading upwards, take it off and blow gently into it you should hear a click and one when you let the air out if so then clean out the steel or plastic pipe you took it from, it normally blocked with soap goo, replace the pipe and try the machine again eric

you may have to take the top off in order to see if the water inlet valve is operating as that's where the water fills from eric