MTX (SLH-T7512X2-A) Car Speaker - Answered Questions & Fixed issues


Hi there,

Actually, you could be in luck.

If you are getting 'absolutely nothing', it could be something simple. Open it up (carefully) and make sure the wires are secure on both the speaker and the inner connection leads.

I've come across several this has happened to that were brand new.

Good luck
Mike

MTX... | Answered on Jul 29, 2010 | 193 views


nice way to ask something :) you must open the subwoofer box and check the connections. the problem is bad contact. with cold all metals shrinks and with warm they expand and make contact.

Don´t forget to rate.
Thanks

MTX... | Answered on Jun 17, 2010 | 64 views


You cant bridge it to the MONO AMP . You can only bridge subs & speakers to 2 CH & 4 CH AMPS that are bridgeable. Because if it appears that there is 2 channels on a Mono amp its so its convenient for you to hook up 2 4ohm subs to it easily But both channels are actually connect internally together in parallel inside the amp unlike a 2 channel they are separate.

So just connect your mtx 9500 to a plus and a minus and doesnt matter which since all the + terminals of are connected together and - are connected together already.

Whats important is on the side of the sub/box it reads 2 ohms. The lower the ohms the more power the Mono amp will put out. Mono amps are designed to handle 2ohm loads.

If it reads 4ohms The MONO amp is the wrong amp to use cause the power will be weaker. So if you have a 1000 Watt Mono amp at 4ohms the sub will only get 500 WATTS Max while a 2 ohm will get the full 1000 Watts.

If it reads 4 ohms connect it to a 2CHANNEL AMP and BRIDGE IT (connect + of the sub to 1st channels positive of the amp then connect - of the sub to 2nd channels negative of the amp) . The power will be doubled when you bridge it on a 2 channel amp. NOW if it was a 2 ohm sub and you bridged it to the 2 channel amp it will fry the subs and ruin the amp. 2 CHANNELS CANT TAKE A 2OHM LOAD BRIDGED OK.

MTX... | Answered on Apr 08, 2010 | 439 views


THE GREEN LIGHT SHOULD SHOW WHEN AMP IS POWER UP AN RED WHEN IN PROTECTION MODE

MTX Car Audio &... | Answered on Sep 12, 2019 | 29 views


Try eBay Often available there from private sellers

MTX Car Audio &... | Answered on Aug 25, 2019 | 25 views


I was having a similar issue. I checked every wire from the battery to stereo to amp, checked the ground, pulled the stereo to double check the wiring was all correct. Everything seemed good so I thought it had to be my battery not putting out enough power. Tested it and it was good. What it turned out to be was the connection from the power cord to the battery. It had a tiny bit of built up corrosion that was making the amp go into protect mode. Cleaned it up and hooked it back up and has been golden since.
The link attached is pretty straight up on what you need to check for different circumstances. I'm guessing it's a low voltage issue. Good luck

MTX Car Audio &... | Answered on Aug 23, 2019 | 38 views


you have to first note the ohm load the amp can handle and wire the speaker that ther amp can handle

MTX Car Audio &... | Answered on May 13, 2019 | 27 views


Check the wiring 1st then go down the line...Check speaker connections..Look at your power,ground and remote wire hook up

MTX Car Audio &... | Answered on Oct 18, 2018 | 46 views


Since this is a vintage item, the cost is whatever the market will bear, wherever you're trying to sell it. I would suggest checking current prices on sites such as eBay, where one is currently being offered to sell at $200, while another is being offered for $90. The perceived value is what determines the selling price at this point, because the MSRP is long irrelevant by now, being that it's a discontinued item.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/reginald_bec291de192ca44f

MTX Car Audio &... | Answered on Jul 08, 2017 | 43 views


The mtx thunder is a 4 channel amp. 4 channels can't be bridged to 1 speaker. You can only use one side of that amp to bridge your speaker. Unfortunately your now only using half your amp.

MTX Car Audio &... | Answered on Nov 25, 2016 | 408 views


You have a short somewhere in the speaker wires.

MTX Car Audio &... | Answered on Oct 05, 2016 | 134 views


250wrms is the highest they can take each. So look for an amp that does 500 wrms x1@ 2 ohms or one that does 250wrms X2 @ 4ohms.

MTX Car Audio &... | Answered on Sep 01, 2016 | 189 views


Take both positive leads to the positive of the amp. Both negatives from the sub to the negative of the amp. Utilize the bridged output connections. This would present a 3 ohm load which would be around 100 watts rms (rough estimate)

MTX Car Audio &... | Answered on Aug 17, 2016 | 360 views


If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/

MTX Car Audio &... | Answered on May 06, 2016 | 435 views


It is actually in the controller, if you turn the remote all the way down and press on the controller until the bass goes off, you will be able to turn the bass up and down with the remote, mine worked but stopped after a month, I tried adjusting the amp but then I noticed that if I wiggled the knob on the remote that it would work, I mashed mine until it worked again and velcroed it to my console sonibcan get it on and off easily.

MTX Car Audio &... | Answered on Jan 31, 2016 | 498 views


you can put them in one box you will need a good port hole if you do.How to build subwoofer box

this link is on how to hook up speakers Subwoofer wiring diagrams \

good luck

MTX Car Audio &... | Answered on Nov 14, 2015 | 198 views

Not finding what you are looking for?
MTX (SLH-T7512X2-A) Car Speaker Logo

4 questions posted

Ask a Question

Usually answered in minutes!

Top MTX Car Audio & Video Experts

Professor_V
Professor_V

Level 2 Expert

93 Answers

Mike Duncan
Mike Duncan

Level 2 Expert

219 Answers

Philip Armitage

Level 3 Expert

437 Answers

Are you a MTX Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...