20 Most Recent
Kingston Sdc10/32gb Flash Memory - Page 5 Questions & Answers
I have 4 gb kingston
click start control panel administrive tools ,computer management ,device manager scroll down universal serial bus controllers you should see a yellow question mark?
right click to reinstall drivers or
if you can see your usb drive but its not working
ports(com&lpt)right click update driver
check the USB leads that attach to the motherboard usually red-white-green-black make sure they are securely seated and have no dust build up on them dust will cause static and a lot of unforeseen problems for a computer and its parts also
scroll to disk drives if you can see your drive + to expand right click you should see options to update driver,disable,uninstall scan for hardware changes. or
select properties you should see options in the general tab to troubleshoot,policies,volumes,driver and details under the driver tab you will have the options to check the driver details,update driver,rollback driver or uninstall
hope this helps
don
3/1/2011 4:57:16 AM •
Kingston...
•
Answered
on Mar 01, 2011
I CANNOT FORMAT MY KINGSTON
Click Start
Click Run
Type CMD
Press Enter
Type CHKDSK /F m:
where 'm' is the drive-letter assigned to the Kingston.
When this "check-disk" completes, Windows will remove the "read-only" attribute.
11/15/2010 8:28:29 PM •
Kingston...
•
Answered
on Nov 15, 2010
My flash drive cant be
If your pc has virus it wont allow to format either the pc or the flash drive may have some virus in it try out to insert in virus free pc and try to format it..
8/20/2010 9:03:54 AM •
Kingston...
•
Answered
on Aug 20, 2010
My 4GB USB is not reading on any PC anymore. I
Ok what you need to do is go into device manager, remove all devices from there remove and delete any drivers. reboot. Now try inserting the USB device again. If after doing this the PC still will NOT, "See" the device. Then this is Bad. You have few options at this point. If you can, please try and use it on another PC, see if it will work on that one. If it again will NOT work, then we must now assume that the Drive has faulted in such a way as it is unrecoverable. I suspect what has happened is that the USB drive has been "Spiked" It may be damaged beyond repair.
It may be possible to recover data but I would doubt it. You WILL be able to IF it can be "Seen" but if not, then I do not think you will be successful.
www.usbdriverecovery.org/ -
www.softwarepatch.com/tips/howto-file-recovery.html -
A couple of data recovery links above. Good Luck.
3/30/2010 5:54:06 AM •
Kingston...
•
Answered
on Mar 30, 2010
My phone has been puk, what will i do?
PUK code can be given only by your service provider which is specific for each and every mobile number.
Contact your sim customer care department over phone. Its free of cost to get the pin or puk no. If you cant contact through your phone get some other phone and contact them.
Go to the nearest service outlet of your service provider they can also help you.
There is no other go than the above procedure only your service provider cangive it nobody else in this world nor any software.
Go to the below link and you can confirm that the above procedure works and there is a testimonial given by the customer too. http://www.fixya.com/support/t3582685-phome_lg_ke670_put_security_code_phone
3/11/2010 11:00:55 AM •
Kingston...
•
Answered
on Mar 11, 2010
The wires are exposed that lead to the power ac
Wires that lead from your AC, (Power), outlet, TO the AC adapter? If so, throw that adapter in the trash before it starts a fire.
Look online. There are many choices for a new AC adapter.
8/4/2009 10:23:03 PM •
Kingston...
•
Answered
on Aug 04, 2009
Memory problem
Hi furgan_138,
Did it appear to compete the password creation successfully? When you create a password on these drives it actually splits the storage area into two peices. A public zone and a private zone (private zone is the area that is password protected). Perhaps you seleted as much as you could for the private zone and the 18MB is actually the public zone you are seeing. Try logging in and check what capacity you see on the private zone.
Kingston Tech Support
1/14/2009 6:02:03 PM •
Kingston...
•
Answered
on Jan 14, 2009
My Employer Says They Are Going To Cut My Wages. Can They?
If you are in the middle of a contract, then cutting your wages is almost certainly a violation of your employment law rights. While I am by no means an expert on this matter, I did have a similar issue years ago - mid-contract wage cuts - and I hired an
employment attorney to fight the case on my behalf. It turned out that my employer was basically looking to scare people into taking the wage cut.
They got into some pretty serious legal trouble for their transgression, and nothing happened to me in terms of wage cuts after that. If you are between contracts, your employer can re-negotiate your salary, but as far as I am aware, if you are in an agreed-upon contract, they cannot just decide to reduce your salary. If you want to settle matters, contest this action with support from a legal professional.
Solitaire master has a hang
clarify pi please. if you meant pi to mean main screen picture, you probably have used up your free time on this program.
Not finding what you are looking for?
