20 Most Recent
Hoover HTC243 Top Load Washer - Page 4 Questions & Answers
Does the hoover 200m 4.4kg top loading washing
Hi just read your posting.It should be in the center of the agitator.Pull the center out and there should be a lint bag attached to it.Unfortunately they do not stop much lint from getting on the clothes.Hope this helps and please reply if you need more help.
Hoover 700LB Stops at the wash during the wash
It sounds like the timer is bad. Try another cycle like delicate, or normal, or heavy duty. If everything works on another cycle then it is probably your timer. If it doesn't work and you have the same problem, then it is probably an expensive fix. Best of luck
When using the washing cycle only part of the
I have the same machine and in the past I have found that soap can build up in the pressure switch tube if this happens the machine may see that it has not emptyed.
It depends on what part of the cycle it is stopping on.
The pressure switch tube is accessable from the back and is conected to the outer part of the bowl assembly it is in most cases a clear plastic tube that with care can be removed and bu blowing gently into the tube you should here the presure switch click if it dose not click then maybe it is blocked. A small piece of wire may free it otherwise it meens taking the top off and gaining access to the top of the tube.
Hope this is of some help
Hoover 600MB Top Loader, Won't Spin
I have the same problem. Just started missing the spin cycles and now I need to find which part to replace.
So far I think it could be: Aged contacts in the Timer, a faulty spin/no spin switch, or something to do with the brake/release mechanisms etc. ..I do know that the problem is electrical because everytime the motor starts the spin works fine; therefore eliminating in my opinion, the mechanical gearbox bits as a cause.
Hoover washing machine top load, model 550m.5.5kg
water leak from cold hose nothing to do with other problem. tighten hose connection and fit a new hose washer
overfilling probably because air chamber blocked. remove lid. you will see a pressurestat somewhere at the top - usually round with anything from 3 to 7 wires and a small tube underneath. follow hose down and it connects to the air chamber. make sure this is free of gung and check hose for splits and has no blockage.
to check the pressure stat itself, attach your own hose to the stat and while machine in fill mode, blow down this hose and you should hear a click and water intake will stop
Spin drying cycle allways go's off balance
- There are damper pads beneath the main support housing
on the of the base of the washer. If the tub does not recenter or if
the machine machine vibrates to much, replace the damper pads.
- If the tub leans too much to one side, check tub/centering spring. It maybe broken or detached.
NOT SPINNING OUT DRY ENOUGH
There is a partial blockage in the drain line. You need to remove the pump and check for obstruction at the impellers. If clear, check the pipes from the drain motor back to the drum and to the pipe outlet for partial blocking.
Hoover hpe236 drum doesn't turn during wash cycle
Watch the motor when it is supposed to be running. If nothing, measure for voltage across the brushes and across the motor power terminals. Make sure the motor will turn freely by hand. If power is present, there may be an open wire to either the field winding or one of the brushes.
Not finding what you are looking for?