Top 20
Bunn -O-Matic Corp. 2 Warmer Auto Brewer Black Questions & Answers
Bunn VPR Series warming too hot
You will need to check the heating element wiring to see that isn't a short on the neutral side. This could cause them to continue to heat even if the thermostat is working. If all wiring is ok check the function and resistance given by the thermostat.
Inave a Bunn VLPF coffee brewer, water is leaking
THe most likely answer is that the tube that leads to the sprayhead is clogged with lime. You will need to remove the spray head wich is located above the brew basket and make sure the holes are not clogged with lime. Use a wire brush to clear them. In the field I would use a deliming spring but you may need to go to a lowes or home depot to find a tool you can use to clear the tube wich is what the spray head screws onto or just goole deliming spring and try to order one off line. It is a long flecible very tightly wound dpring about 14 inches in length or so. www.midstaebeverage.com
My bunn makes great coffee, but after 10 min in
If by meaning the coffee pot, the bottom warmer maybe loose and dropped inside the machine.Normal brew temp is 195 degrees out of tank.There also may be problem with the hi-limit ,t-stat or element.
The water comes out warm
Is it still under warranty? Bunn should take care of it for you if it is. Usually if the coffee is only warm it may mean that a thermal limit has tripped. The water stays warm because the tank has a heater blanket that is wrapped around it but you aren't getting any power to the heater that is in the tank.
[email protected]
I have a bunn auto
Either the coffee grind is too fine, too much coffee or incorrect sprayhead. Count the amount of holes on the sprayhead.
Bunn VPS Series Commercial coffee maker won't brew
Hello. I would like to suggest that you pour in water, with a container under the funnel, until water does come out, it sounds like the water has just evaporated too far, and it requires more than a pot to bring it to the top. In the future, if you do not use it for a day or more, you need to unplug it, or just pour a pot of water in to keep it at level, as this unit heats all the time it is plugged in, and can actually evaporate all the water away, blow the element, damage the thermostat, or worse permanently damage the unit.
here you can find the user manual:
http://bunnomatic.com/pages/techdocs/manuals/pourbrew_warm.html
Hope that helps, and thank you.
Inconsistent water amount being dispensed
It sounds like there is some build up in the brew line, find the nearest bunn dealer and get a delimming spring, then remove the shower and run spring through brew line.
BUNN CWTF 15
Hello. Most likely the heating element for the tank has failed. This unit has a warmer that has the wattage of a 100w lamp, wrapped in foil on the outside of the tank, and just helps keep the water in the tank more stable at the normal brewing temp, that is why it is warm to start, but then is cool, or cold when you brew. The main heater in the tank, goes in from the top. Could you do this? well, there are 2 other items, a thermostat, and a hi limit that can cause this same problem, if you can test them, they should read zero resistance, like a closed switch. The element should read 10 to 20 ohms resistance, depending on the wattage, and voltage. It should be relatively easy to replace, just take your time, get the manual here :
http://bunnomatic.com/pages/techdocs/manuals/pourbrew_warm.html
Hope this helps, and thank you.
Water supply for Bunn coffee maker
open the cover on the brewer- depending on your model, it could be the front or the back cover. look for a brew timer dial. turn this up slowly, running a brew each time to see if you now have a full pot
I have an older Bunn-o-matic
Here are some possible causes ,the hi temp cut out ,thermostat, or heating element are bad .a continuity tester can determine whitch one .Also you could have a burnt off wire . The reason the water is still luke warm is a electic warming jacket that bunn put around the water tank to limit the therostat cycles during off peak usage very fixable hope this helps
Not finding what you are looking for?