20 Most Recent Quinny Buzz Jogger - Page 7 Questions & Answers

Hi handle is replaceable

Hi it sounds like you need to replace the front wheel, but 1st take the wheel off wash it in soapy warm water dry then spray wd40 see if that works.

Hi you can use a velcro stap to hold it together or Dorel may sell them.

Hi they are always selling them on ebay.

Hi apparently you can get it replaced at any bike shop. I haven't tried this yet as I don't need to. Worth a try though.

The US distributor for Quinny Strollers is below. They may cary the part you are looking for as well...

Dorel Juvenile Group USA
Canton Commerce Centre
45 Dan Road
Canton, Massachusetts, USA02021
(781) 364-3100
(800) 544-1108

Normally you can get these in your local bike/cycle shop.

f the dreami carrycot or the maxi cosi car seat are attached, these will have to be removed first. Apply parking brake Release the handle bars by unclasping the silver clips on the frame. Push down handlebar to lowest height as you press in the silver button under the quinny logo on the very top of the handlebar( in the middle of the foam padding) with a downward thrusting motion. The chassis should then collapse for storing. To unfold then release the transport clip on the left hand side with the red sticker on it and unfold upwards adjust handlebar to required height and lock by closing the silver clasps either side of the frame. If you want me to do a pic/video demo let me know. HTH

No they wont fit sorry

Not sure what clasp you mean on the Zapp. My Zapp certainly doesn't have one. Do you mean the Buzz? If it's the Buzz then you can contact Dorel UK on 01842 763 281 (Mon ? Fri, 8:30 am to 4:30 pm) They are the sole suppliers of parts for the Quinny range. They should be able to help.

Doesn't look like it's available in Canada. However, take a look at http://shop.ebay.ca/?_from=R40&_trksid=p3907.m570.l1313&_nkw=quinny+buzz+box&_sacat=See-All-Categories It's from the UK so Postage is $19 ish. Hope this helps.

You need to buy the foot rest adjuster set £20 + 3.99 from Dorel UK 01842 763 281 (Mon – Fri, 8:30 am to 4:30 pm) They are the sole supplier of parts for Quinny.

Check your tyre pressures, if they are too soft it will feel like the buggy is really heavy. the other thing that will affect it is the weight of your child. My son is quite heavy for his age and coupled with whatever is hanging off the buggy, makes for one heavy buggy! You might also want to lubricate the axles.

The Lascal BuggyBoard will fit on the Quinny Buzz in both the Pram and pushchair mode. However, it's a bit of a tight fit for your toddler. We had the same issue.

The Quinny Buzz can only be folded/unfolded with the seat in the most upright position facing forward. If this is the case and it won't unfold, remove the seat first by pushing down the two grey release buttons either side of the frame. It may be the case that the gas strut (automatic close/opening mechanism) is seized and will need replacing. This can only be done by Dorel UK 01842 763 281 as it is a pressurised unit. Hope this helps

Dorel UK 01842 763 281 (Mon – Fri, 8:30 am to 4:30 pm) are the sole service/spares supplier for Quinny in the UK. Thry them for new wheels unless there are any on Ebay

Sounds like you're either very unlucky or have a thorn or something similar stuck in the tyre, poking through into the inner tube. I suggest you take out the inner tube and carefully run your fingers around the inside of the tyre to feel for anything that may be causing your problem.
Failing that, you can by a product for road bikes called Panaracer Flataway Tyre liner http://www.wiggle.co.uk/p/cycle/7/Panaracer_Flataway_Tyre_Liner/5300003783/
It can be cut and stuck to the inside of the tyre, preventing anything puncturing the inner tube through the tyre wall. Good Luck

I have the same problem with my 2006 model. Dorel UK 01842 763 281 (Mon ? Fri, 8:30 am to 4:30 pm) can supply the Foot Rest Adjuster Set (i.e the grey buttons at either side of the footrest) They are £20 + 3.99 P

This happened to my wife the other day, I found that the main pivot bolt had pulled through the plastic pivot/collapse assembly. This part is rivoted to the frame so without drilling it out and replacing with an ugly nut and bolt you will have to source a new frame. I got mine from Ebay, I found someone selling lots of quinny buzz bits and asked if he still has the frame he said yes but the handle bar no longer extends (Hence im on here looking how to swap the two), Problem solved!

I also found out from Quinny that the Buzz has a 2 year manufacturers warranty, where Motercare insisted it was 1 year, so dont let them fob you off.
Hope this helps
Chris.

Hi, I believe you activate the folding mechanism by pushing down on the two grey rectangular plastic buttons on the black side hubs (at the mid point of the pram).

In any case you can download the complete instruction manual for the pram for free at http://www.freebabymanuals.com/quinny/prams

Hope that helps.