20 Most Recent
Rangemaster Toledo 90 (Dual Fuel) Dual Fuel (Electric and Gas) Kitchen Range - Page 2 Questions & Answers
Setting the clock
To set the time, turn and hold the Timer knob to the clock symbol = and at the same time turn the Adjusting knob left or right until the clock shows the time of day. Remember this is a 24-hour clock. Let go of the Timer knob and it will spring back to the vertical, oven manual setting.
Gas oven lights pilot straight
Sorry to read about your problem, I hope this helps you out.
I will assume you have the gas. there is no thermocouple, your oven use electronic ignition.
you may have a bad liter or you need to clean the grills
Hotplate Top Enamel or Stainless Steel
Hot soapy water, soft cloth. Any stubborn stains remove gently with a nylon scourer.
Pan Supports, Wok Cradle (some models only)
Enamel coated Cast Iron or Stainless Steel
Cif Cream Cleaner- Faberge Lever and a nylon scourer.
Dishwasher.
Burner Caps Enamel
Cream cleaner, nylon scourer. Dishwasher
Burner Trim Rings (some models only) and Burner Head
Aluminium
Cif or other cream cleaner with a soft cloth. Be careful not to be over vigorous.
Griddle Plate (some models only)
Non-Stick Surface
Allow to cool. Wash in hot soapy water. Do not use abrasive cleaners/scourers. Dishwasher.
I tried to help you. Please help me and Rate/Vote on my response. We take the time to answer your question. take the time to rate us.Thanks and good luck
4 Thumbs - Very Helpful
3 Thumbs - Helpful
2 Thumbs - Somewhat Helpful
1 Thumb - Not Helpful
I need to reset the clock for summertime but cant!
push the button on the front of the stove that says "clock" and then turn the dial (same one you use for timer and oven temp) till you get the time you want, then LEAVE IT ALONE and it will set itself. Don't touch anything once you have the time set with the knob.
Ceramic Hob Stained and Marked
We Use Debruce Polish on all our cooktops. Debruce also works on
stainless steel and polished granite, marble, porcelain, formica and
glass. DeBruce is non-toxic odor-less and eco-friendly. You can get
DeBruce on line at debrucepolish.com.
I have 0.00 and aoto flashing on and off.
After a power failure most digital clocks have the zero's and auto flashing. These ovens will not work if clock(time of day) is not set. By pressing incorrect buttons, you can complicate things further. Recommend turning off power to oven for a few seconds, then follow manual for resetting clock, which is usually holding down the 2 buttons on the left hand side simultaneously, and holding down these two press the + or - key to advance clock.
Range master toledo 90
I would follow these requirements if I were you:
The cooker must be connected to the correct electrical supply as stated on the voltage label on the cooker (This is obvious so far!). It should be connected through a suitable cooker control unit incorporating a double pole switch having a contact separation of at least 3mm in all poles (This means one of those big red switches with "COOKER" written on them). The cooker must NOT be connected to an ordinary domestic power point. The cable size used should be between 6mm squared and 10mm squared twin and earth. Where the installation is protected by a 30 milliamp sensitivity residual current device (RCD Breaker), the combined use of your cooker and other domestic appliances may occasionally cause nuisance tripping. In these instances, the cooker circuit may need to be protected by fitting a 100 milliamp device. This work should be carried out by a qualified electrician.
Setting the clock
Press and hold the two leftmost buttons under the clock display - with a picture of a bell and a steaming pot.
While holding these, press the - and + buttons to adjust the clock
Not finding what you are looking for?