20 Most Recent Keurig Elite B40 Coffee Maker - Page 3 Questions & Answers

the unit works on a double suction set up, the heater draws water when needed, then the internal tank will draw water from the outside tank when needed. If all systems are not calling for water at the same time it will not work, you cant trick it. If your worried about freezing, run some non-toxic R>V> anti freeze thru it. It will also keep it from molding if freezing is not the issue.

First try using a paper clip or long pin to clean the 2 tiny holes in the upper prong that pokes thro the top of the coffee cartage. I had the same problem and that fixed mine

sounds like water has gotten into the electronics, let it dry out and see if it goes.

Have you got your power cord checked?

How did you clean your keurig? The way that I do it is fill the tank up with vinegar and run it through. The way that you might have washed it may have clogged it up. Using the vinegar will clean and unclog the machine.

It could be the heating element inside the machine. Or I could be the water pump. The water pump pushes the water into a chamber where it is heated up before it goes into the cup. If there is a manual near by, read the part under water pump.

There is a filter screen under the machines tank you have to take the machine apart to clean that screen.

It was over filled beyond the Max line.

Stop ruining the environment of the world with this trash

Inside the coffee maker there is a small screen filter that must be be half plugged you have to take the machine apart to clean it, it is hard enough job to fix it.

1. Power off machine.

2. Using a metal paperclip, insert it into left side of top needle. It must insert at least 1" deep. Insert it into slot on right side and again from back of needle.

3. Remove KCup cradle. Separate bottom from top. In the top section, insert the paperclip up into bottom needle from the bottom upwards. It will not go all the way thru and this is normal.

4. Reassemble KCup cradle and reinsert it back into coffee maker.

5. Power on machine.

6. Brew a cup of water only. There may be coffee grounds in the water and these should eventually clear during the remaining steps. NOTE: A large cup brew cycle should output a full 8 ounces (235cc). Less means there is still a blockage.

Good luck calling Keurig. I had the same problem. ll they wanted to do was sell me a new one

I would contact Keurig.com It sounds like a posssible control board problem.

use CLR If you need further help, I’m available over the phone at https://www.6ya.com/expert/robert_e9d0abd7cc2508b3

Call the company, they will usually replace it for free and ship it.

Contact Keurig via phone or website to confirm but the website says only the K10 right now.

lot of time you have a magnet in the water tank fill it with water and gently tap the side of machine the magnet is block or jam on empty


THANKS FOR USING FIXYA


PIERRE