20 Most Recent
Brother SE-270D Computerized Sewing Machine - Page 5 Questions & Answers
The piece that looks like sharp metal under the foot dose not work
That is called your feed dog. Remove any embroidery attachments and check for a switch that allows you to lower the feed dogs. It should be on the back side of the machine directly behind the sewing area. Another possibility is that you have it in bobbin winding mode.... but then your needle wouldn't work either.
Bobbin trouble
try a different bobbin and see if that helpsalso there could be something wrong with the hook and hook racethose parts may need to be checked
Thread wont loop, it doesn't sew?
It loops, it's just that your shuttle isn't catching the loop. The loop is formed on the upstroke of the needle on the back or "scarfed" side of the needle. If the shuttle point doesn't catch that loop, no stitch. First make sure you have a fresh needle. If still no stitch... take it in for service. (clean, lube and time)
Thread bunching and bobbin winder quit
This sounds a lot like you've forgotten to lower the presser foot. (this leaves the tension discs open and causes serious issues below the material.) Double check that and if still having issues post again.
My brother 270D keeps shutting off
Take your machine back to the other side of the house. See if it works better there. If it does have an electrician come out and check the new location's power. There may be a problem in the houses wiring.
Bobbin thread pulls to the top with all but Brother brand
Your machine was designed to work with the Brother brand of bobbin thread. Any other thread will cause tension issues. If you want you machine to work with another brand of bobbin thread I suggest purchasing an additional bobbin case and have it calibrated for use with the other brand of thread.
Brother 700e
Try these suggestions
1. Change needle
2. Rethread the machine--top --make sure to use every thread guide
3. Take the bobbin out --make sure it is inserted correctly into the bobbin
Case, & make sure the bobbin is turned the correct way
4. make sure the thread has not come off the thread take up lever
5. Clean under the needle plate & in the bobbin area for lint or threads
Not finding what you are looking for?