Nor-Lake Walk In Cooler 6ft x 8ft Norlake Indoor No Refrigeration - Page 9 - Answered Questions & Fixed issues

Question edited for better English and CAPS for maker name. Yes, that is exactly how it is supposed to work and is called 'cycling;. 15 minutes between cycles is perfect. What happens is this. Your fridge is at the perfect 3' centigrade (37.4 Fahrenheit), so it cycles off the compressor motor, 15 minutes later the temperature rises to 3.2'C (37.76'F) so the compressor cycles on for a few minutes and pulls the temperature back down to 3'C. If you are opening and closing the door or adding things at ambient room temperature like supermarket produce, the compressor will stay on longer to get that perfect temperature and cycle off. If it is doing it every 30 seconds, that is called 'short cycling', and it would need attention. ..

Tammy,This symbol is of a dotted square with a water droplet forming at the bottom.Your water filter should be changed every six months based on average use.Here's a list of symbols FYI....https://www.domex-uk.co.uk/help-advice/samsung-fridge-freezer-symbols/

did you try reset your Norcold RV refrigerator? all you need to do is unplug the power cord from the unit. Then, wait for five to ten minutes and then put it back in. There is another possibility... It is likely trying to use more power than what is available which is why the lights are flashing.

A previous answer by Andrew.... Vacuum out the condenser fins. If that doesn't fix it, you need a service engineer to visit. Either low on gas, or a faulty defrost thermostat has filled the evaporator fins with ice.

Contact the maker direct. This doesn't appear to be a North American Product. If it is supposed to be refrigerated it may be low on refrigerant gas or it may be an electronic process that uses a heat sink and fan. The words 'HP water dispenser' shows there may be more than one model. All question need full 'make model (what is is)'. https://www.google.com/search?q=HP+water+dispenser ..

If your water dispenser on your refrigerator says that it's out of water even though you have already filled it up, and the light keeps flashing, there may be a few things you can try to fix the issue: 1. Check the water supply: Make sure that the water supply line to the refrigerator is turned on and that there are no kinks or obstructions in the line that could be preventing water from flowing to the dispenser. 2. Reset the dispenser: Try resetting the dispenser by unplugging the refrigerator or turning off the power at the circuit breaker for a few minutes, then turning it back on again. This can sometimes clear up temporary glitches in the system. 3. Check the filter: If your refrigerator has a water filter, check to make sure it is not clogged or needs to be replaced. A clogged filter can prevent water from flowing properly to the dispenser. 4. Contact the manufacturer or a professional: If the above steps do not resolve the issue, it may be a more complex problem that requires the attention of a professional technician. Contact the manufacturer or a professional repair service for assistance. It's important to address the issue as soon as possible, as a malfunctioning water dispenser could lead to other issues or damage to your refrigerator.

Hi,
Your drain pan in the back of the freezer is clogged and when you unit goes into defrost this happens. I would turn off the unit, remove the racks and shelves, remove the back wall, at the bottom is the pan, use hot water and a turkey baster or a cup to thaw the ice and clear the pan. Make sure you clean out the drain tube also. Lastly turn back on the unit, I forgot once....
Good Luck I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

It is where the compressor hides. They put a hole in the cover for ventilation. There is also a hole where the pipes go through. This is a question where 'make model (what it is) is useful and where a picture tells a thousand words. You can add images very easily.

Can i bypass the bin full sensor

Hopefully this link will help you.... https://diy.stackexchange.com/questions/15195/how-can-i-mitigate-copper-naphthenate-copper-green-smell-indoors

If you have installed a Rev-A-Shelf two-basket unit and the shelves are only sliding in halfway, it could be due to a few different reasons:

1. Installation issues: Make sure that the unit is installed properly and securely. Check that the mounting hardware is tightened and that the unit is level.
2. Incorrect installation of brackets: Make sure that the brackets are installed in the correct position and that they are properly aligned with the side of the cabinet. Incorrectly installed brackets can prevent the unit from sliding in all the way.
3. Obstructions: Check to see if there are any obstructions that are preventing the unit from sliding in all the way. This could include screws, nails, or other objects that are blocking the path of the unit.
4. Unit is too wide: Make sure that the unit is the correct size for your cabinet. If the unit is too wide, it may not be able to slide in all the way.

If you have checked these potential causes and the issue persists, it may be helpful to contact Rev-A-Shelf customer support for further assistance. They will have the necessary expertise to help troubleshoot the issue and identify a solution.

If your Monogram refrigerator is only partially not cooling, it could be due to a few different reasons:

1. Dirty condenser coils: Over time, the condenser coils can become coated with dust and debris, which can restrict the flow of air and cause the refrigerator to overheat. If this is the case, cleaning the condenser coils may resolve the issue.
2. Faulty condenser fan: The condenser fan is responsible for circulating air over the condenser coils to cool the refrigerant. If the fan is not working properly, the refrigerator may overheat and not cool properly.
3. Damaged or worn door gaskets: The door gaskets create a seal around the refrigerator door to prevent warm air from entering. If the gaskets are damaged or worn, warm air can enter the refrigerator and cause cooling issues.
4. Blocked air vents: The refrigerator compartment has air vents that allow cold air to circulate throughout the compartment. If these vents become blocked with food or other items, it can restrict the flow of air and cause cooling issues.
5. Faulty temperature control thermostat: The temperature control thermostat regulates the temperature inside the refrigerator. If the thermostat is faulty, it may not be able to properly control the temperature and the refrigerator may not cool properly.

If you have checked these potential causes and the issue persists, it is recommended that you contact a professional appliance repair service to diagnose and repair the problem. They will have the necessary tools and expertise to identify and fix the issue.

You can check this website https://www.autogenius.info/category/pontiac/pontiac-bonneville/

Is the compressor running? It needs to be. You should be able to hear it running and it is normally hot to the touch. Are the condenser fins free of dust and fluff. The best way to clean is with a vacuum cleaner. Airflow is important. Does the thermostat click when you turn it backwards and forwards. It may need a top up of refrigerant gas. Or it may just have reached the end of its life and need replacing. If the compressor has failed, that will certainly be the case.

Maybe bad thermostat or bad fan motor

All questions need FULL 'make model (what it is) as first 3 words. Is it new? Call the vendor as it is under warranty and their task is to leave you with a working machine. Or is it an old machine and you have only just connected water to it, the most likely reason is dry seals or a sticking eater inlet valve. You will need a service call for that.

Question edited for clarity, and add maker. It may need a top up of refrigerant gas, but first check that the circulation fan in the fridge is working. Also make sure the condenser coils are clean. ..

try reseting it by holding power button for 10 to 12 seconds.

Then Wait for at least half an hour before turning it on.