When the panel lights on your Defy fridge freezer are flashing, it usually indicates an error or a specific condition that needs attention. Here are a few steps you can try to troubleshoot the issue:
Power Reset: Start by performing a power reset to see if it resolves the flashing lights issue. Turn off the fridge freezer at the main power supply or unplug it from the electrical outlet. Leave it unplugged for a few minutes, and then plug it back in or switch on the main power supply. Check if the lights continue to flash.
Check Error Codes: Consult the user manual or documentation for your Defy fridge freezer to identify the meaning of the flashing lights or any error codes displayed on the panel. The manual will provide specific information on what each flashing light or error code signifies and any recommended actions to resolve the issue.
Temperature Settings: Ensure that the temperature settings on the fridge and freezer compartments are set correctly. Incorrect temperature settings can sometimes trigger error codes or unusual behavior. Adjust the settings to the recommended levels and observe if the flashing lights persist.
Contact Customer Support: If the flashing lights persist or you are unable to identify the issue using the manual, it's recommended to contact the Defy customer support or an authorized service center. They can provide further guidance and assistance in diagnosing and resolving the problem.
fridges / freezers are meant to placed standing up at all times
laying down creates problems with the oil getting ion top of the pistons in the compressor and blocking the orifice in the evaporator system
you can tilt them as on a fridge trolley or to load and unload but not for any more than a few minutes
Yes as long as the coils that carry the freon is located on the top side of the compressor when laying down. Look at the lines on the compressor. You should see 2 of them. 1 larger than the other. Imagine you are tilting the refrigerator. If the lines are on the right side you can it down on it's left side ok. If they are on the left side you lay the fridge down on it;s right side. Hope this helps.
In most cases no, the reason they don't want them to be laid down when transporting is because they have oil in the refrigerant lines. When the unit is laid down, the oil pools in pipes and can cause issues if the unit is plugged in immediately after being stood up. In order to reduce the chance of something going wrong, allow it to stand up right for 24 hours before you turn it on.
After conducting extensive research, it is difficult to determine the exact reason why the KIC model KB6031 fridge is not switching on when plugged in without further information or inspection. However, there are several potential reasons why this may be occurring.
Firstly, it could be due to a faulty power supply or electrical outlet. It is recommended to check if other appliances are working when plugged into the same outlet or try plugging the fridge into a different outlet to see if it turns on.
Secondly, it could be due to a malfunctioning thermostat or temperature control unit. If the fridge is not receiving the correct signals from these components, it may not turn on. It is recommended to consult the user manual or contact a professional technician for assistance with troubleshooting and repairing these components.
Thirdly, it could be due to a malfunctioning compressor or motor. If these components are not functioning properly, the fridge may not turn on or cool properly. It is recommended to contact a professional technician for assistance with repairing or replacing these components.
In conclusion, there are several potential reasons why the KIC model KB6031 fridge may not be switching on when plugged in. It is recommended to check the power supply and electrical outlet, inspect the thermostat and temperature control unit, and consult a professional technician for assistance with repairing or replacing any malfunctioning components.
After conducting an extensive search, I have found that the best place to purchase a replacement water tray for the Florcraft model 709-3917 is directly from the manufacturer or an authorized dealer. The manufacturer's website, www.florcrafttools.com, offers a variety of replacement parts for their products, including the water tray for the model 709-3917. Additionally, authorized dealers such as Home Depot and Menards may also carry replacement parts for Florcraft products.
It is important to note that purchasing replacement parts from unauthorized dealers or third-party sellers may result in receiving counterfeit or incompatible parts, which can be dangerous and potentially damage your equipment. Therefore, it is recommended to only purchase replacement parts from trusted sources.
In summary, the best places to purchase a replacement water tray for the Florcraft model 709-3917 are directly from the manufacturer's website or an authorized dealer such as Home Depot or Menards.
Based on the information provided, it seems that the Norcold N611R fridge in the travel trailer is experiencing issues with cooling on AC power. The green and yellow LEDs are blinking, and the fridge stops cooling after running for a random number of hours. The gas cooling seems to be working fine, and the fuses, AC/DC power, and power board have been checked and replaced.
One possible cause of this issue could be a faulty heating element. To check if the heater is working properly, you can use a multimeter to measure the resistance of the heater. The resistance should be between 44 and 52 ohms. If the resistance is outside of this range, then the heater may need to be replaced.
Another possible cause of this issue could be a problem with the thermostat or temperature control system. If the temperature control system is not functioning properly, then it may not be able to maintain a consistent temperature in the fridge, which could cause it to stop cooling after a certain amount of time.
It is also possible that there is an issue with the wiring or connections in the fridge. If there is a loose or damaged wire or connection, then this could cause intermittent cooling issues.
In order to diagnose and fix this issue, it may be necessary to consult with a professional technician who has experience working with Norcold fridges.
A blinking orange light on appliances such as refrigerators and freezers indicates that the "supercool" or "superfreeze" feature is active. These features are designed to quickly cool or freeze the contents inside the device. A flashing light serves as a visual cue that the unit is actively working to quickly cool or freeze food. Once the desired temperature is reached, the light will stop flashing, indicating the unit has completed the cooling or freezing process.
It seems that you're referring to an issue with the DIM32D2BSSPR Ice Maker model. When the unit goes through several cycles, it shuts down and the three size selector lights start flashing. Holding down the power button allows you to reset the unit and resume its operation.
Based on the provided information, it appears that there may be a malfunction or error occurring within the ice maker. Here are a few steps you can try to troubleshoot the issue:
1. Check the power supply: Ensure that the ice maker is properly connected to a stable power source. Verify that the power cord is securely plugged in and there are no loose connections.
2. Clean the unit: Ice makers can sometimes experience issues due to debris or mineral buildup. Clean the ice maker thoroughly, including the ice bin, water supply lines, and any filters or screens. Follow the manufacturer's instructions for cleaning and maintenance.
3. Reset the unit: As you mentioned, holding down the power button allows you to reset the ice maker and get it working again. If the issue persists, try performing a factory reset if your model supports it. Refer to the user manual for instructions on how to reset the unit.
4. Contact customer support: If the problem continues to occur despite your troubleshooting efforts, it's recommended to reach out to the manufacturer's customer support or service center. They can provide further assistance, troubleshoot the issue over the phone, or recommend a professional repair service if necessary.
Remember to consult the user manual specific to your model for any additional troubleshooting steps or guidance provided by the manufacturer.
All questions need full 'make model (what it is)' please.
Do you have a freezer at the top and a fridge below it? That box is just a cold air vent from the freezer. There is often a circulating fan in there, but it could be elsewhere.
The issue with a warm fridge and a cold freezer is that the defrost for the freezer has failed and the evaporator is a solid lump of ice and not passing chilled air, OR, the vent is boked with ice. The is a defrost timer and a heater element at the rear of the freezer back panel.
If the refrigerator freezer is cold but the refrigerator is warm, the defrost thermostat might be defective. Several times a day the defrost heater turns on for a few minutes to melt away any frost that may have accumulated on the evaporator coils.Mar 3, 2015
Yes we do. Is this yours posted as 'Anonymous'?
My problem is that my water timer will open the valve for a manual watering, but when it's the time I have set for it to come on, the valve doesn't open.
That is a problem with the electronics controlling the timer. Return it to them for servicing.
..