20 Most Recent
Hotpoint Aquarius WF220 Front Load Washer - Page 6 Questions & Answers
Keeps saying test
Check hoses all ok connected .Water turned on is the door lock ok/ mains ok....
11/4/2009 12:37:02 PM •
Hotpoint...
•
Answered
on Nov 04, 2009
The machine does not work. All the LEDs are
Hi,
If ALL the led's are flashing then the main power board needs replacing, however, if just some of the led's are flashing then its gone into error, the lights flashing give a code, more info needed like model number? and which lights flashing.
As i said, if its ALL the lighst then new power module needed.
Please rate my help.
Thank you
10/30/2009 9:11:09 PM •
Hotpoint...
•
Answered
on Oct 30, 2009
Spin cycle
Most likely your drum bearings are worn out. This is a major repair.
You may be better off replacing the machine.
Ash
10/22/2009 11:49:53 AM •
Hotpoint...
•
Answered
on Oct 22, 2009
Hi i have aburning smell coming from the machine
Be sure the lint filter is clean, and the temp sensor blown clean. Sometimes when cleaning the lint filter the some small amount of lint drops by the filter or screen and land on a hot spot. Lint can catch fire so clean with a air hose or vacuum cleaner - Good luck and be safe
10/16/2009 4:38:43 PM •
Hotpoint...
•
Answered
on Oct 16, 2009
F-08 error message on Hotpoint Washing machine
If it works fine with the heater off then i would say that fault appears to be element..the readings you get seem okay, put you meter onto megs and check, with wires off if you get electrical leakage between live and earth...Body....of element, it could be element is heating with no water in machine causing it to burn out..this is a problem with this machine...Wish you well
10/7/2009 10:59:28 AM •
Hotpoint...
•
Answered
on Oct 07, 2009
Will not spin
If there is water in it clean out filter,,located within Sump hose
10/6/2009 6:40:46 PM •
Hotpoint...
•
Answered
on Oct 06, 2009
How to attache drive belt to drive drum
Remove rear cover of washer, and top cover also, tilt washer towards you, get someone to hold washer steady, fit belt round motor pulley,and slowly feed belt round drum pulley, watch your fingers, keep feeding belt round oulley, turning drum at same time, it will be tight, but persist, and belt will go on.
Please rate my solution.
Thanks.
9/28/2009 7:30:42 PM •
Hotpoint...
•
Answered
on Sep 28, 2009
I need to remove the bearings from the drum of my
Its not impossible but a real battle without the correct tools. If at the back of your washer, you have the main arm assembly, then firstly remove the belt and then the pulley.Undo the nuts holding the assembly and in short, pull that assembly off by pulling it towards yourself. Once off, you will see the bearings and seal that need to be replaced. Once done, reassemble carefully and god luck.
9/23/2009 6:06:28 PM •
Hotpoint...
•
Answered
on Sep 23, 2009
Not finding what you are looking for?