Hotpoint Ultima WF865 Front Load Washer - Page 7 - Answered Questions & Fixed issues


From the diagrams on line, I think you have to remove the bottom panel to get at the screws in the bottom. The top appears to be able to be pried up on the front side. That's as far as I can help you.

Hotpoint Washing... | Answered on Sep 29, 2018 | 167 views


If it trips the RCD then you have an electrical fault. Washing machine can do this once they are a bit old, or if they have had a water leak. The water gets into the electrical equipment and causes a fault that trips the RCD. If you have a circuit without an RCD try that. If it still trips, then the fault is serious and you will need to get it repaired. You can also try putting the washing machine into a warm place for a few days to see if it will dry everything out. Sometimes this will cure a fault if it is due to dampness.

Hotpoint Washing... | Answered on Sep 01, 2018 | 45 views


sadly we can not as do not have all of hotpoint 's records here try their website

Hotpoint Washing... | Answered on Aug 28, 2018 | 48 views


If your description is accurate and the drum is loose enough to put the drive pulley or wheel so far out of alignment the belt has come off it is almost certainly the main bearing that is at fault.
The machine must have been making a lot of noise for a considerable time to have reached the current state and it would be wise to expect more damage and expense than is usual.

Hotpoint Washing... | Answered on Aug 26, 2018 | 49 views


Remove the two top rear screws then slide the entire top forward....some units slide towards the rear.

Hotpoint Washing... | Answered on Aug 11, 2018 | 43 views


Check to make sure that the water valves are open and water is getting to the machine.

Hotpoint Washing... | Answered on Aug 05, 2018 | 821 views


Microwave ovens have a special paint inside them that prevents the microwaves from hitting the metal. When the paint gets damaged or when the oven is used with metal in something or nothing at all, the continued use will cause what you are talking about. That unit is not made any longer and repairing it would involve removing it from its installation and taking it into a shop. You would be money ahead to replace it. However you should request delivery, installation and haul away of the old one because electronics cannot be just put in the trash,

Hotpoint Washing... | Answered on Jul 28, 2018 | 57 views


search for a video on YouTube or
HOTPOINT website

Hotpoint Washing... | Answered on Jul 16, 2018 | 54 views


Could be a defective latch or a controller fault preventing release

Hotpoint Washing... | Answered on Jun 29, 2018 | 25 views


check inlet filters if ok make sure water solenoids ok

Hotpoint Washing... | Answered on Jun 15, 2018 | 26 views

Not finding what you are looking for?
Hotpoint Ultima WF865 Front Load Washer Logo

139 questions posted

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

vince

Level 3 Expert

1234 Answers

gbob59

Level 3 Expert

3042 Answers

James Hehling
James Hehling

Level 1 Expert

11 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...