20 Most Recent
Hotpoint Aquarius WD640 Front Load Washer/Dryer - Page 4 Questions & Answers
Where is the drain filter?
turn machine on its side under neath you will see metal clamp undo this and filter or area were large coins will fall and stay will open
have cloths ready for some water spillage
8/6/2014 8:35:22 AM •
Hotpoint...
•
Answered
on Aug 06, 2014
Error message
Hotpoint’s are designed to go into test mode when the start button and
the on/off button are pressed at the same time. If you are stuck in
Test mode, simply hold the start button down until it comes out of test
mode, then hold both the start buttons and the on/off button down until
you see ‘D:end’ (or similar message)."
5/19/2014 10:38:40 AM •
Hotpoint...
•
Answered
on May 19, 2014
How do I get the clips off a washing machine filter?
The clip secures the SUMP HOSE which has the filter in it ,Put an old towel under this and give it a tap with a flat bladed screwdriver this will loosen the White clips that hold on the hose,then you remove filter and clean noting which way it came out , refit
5/8/2014 5:40:30 PM •
Hotpoint...
•
Answered
on May 08, 2014
Noise from machine
1.check if the bra wire is poking out of one of the drums.Check for drum bearing failure if your washing machine is noisy on the spin cycle. Drum bearing failure is common when the bearing seals start allowing water to enter. You can take the belt off and spin the drum by hand, and if the drum rumbles, replace the bearings.2.clear the water pump from obstractions like coins or small objects there might be some coins stuck in it that are causing discomfort.if all the above fails try to run the motor alone without the belt if you still hear the noise its the motor that has a problem
3/6/2014 7:57:40 PM •
Hotpoint...
•
Answered
on Mar 06, 2014
Not finding what you are looking for?