Nov. 2, 2019 - Whirlpool recall: full list of Hotpoint tumble dryer models recalled - and how to get a free replacement. Whirlpool admitted as many as 800,000 ...
https://www.hotpointservice.co.uk/safety-notice
..
Hi,There are basically just few reasons :1. Maybe the water pressure is too low2. Hoses are blocked - check that there are no kinks in the cold water fill hose and the waste water hose too3. Clogged inlet valve - the water inlet valve supplies hot and cold water.You can read more about most common washing machine faults here - https://www.justfixed.co.uk/washing-machine-problems/
Hello. If the problem happens every time you wash and is not an intermittent phenomenon, my first guess is your main control board has gotten corrupted somehow(there is a small computer program stored on the board which tells the machine how to operate dependent on which wash options you choose). I had to check extensively for the parts diagram to your unit--there is only one board that controls EVERYTHING...you will need to get the actual model number from the barcode sticker when trying to get this board. It will be located near or on the door. I hope I helped you!
f-05 usually relates to either the pump being blocked or the sump of this particular model being full of coins, color catchers etc. first keep it simple, ensure outlet hose is not blocked or kinked....but if not follow these steps
To sort this isolate from mains
take off back inspection panel.
tilt machine forward- get sum1 to hold it for u.
The sump is the black hose attached to drum.
place a basin under this and loosen jublie clamp using star head screw driver/ 8mm socket,
pull sump downwards and remove any blockage.
note the plastic ball is part of the sump assembley.
refitt the sump again and tighten clamp, pull down firmly on sump to ensure fitted correctly
if there was nothing in the sump it is sumthing jamming the pump, hairgrip, nail, etc.tilt machine forward as above with a basin ensuring isolated from mains power
pump is attached to other end of sump hose, right side of machine as you look in the back.
using flat screwdriver lift plastic tag up and slide pump assembley to the left releasing it from base of machine
clip of plastic cover from top of pump
remove wires from pump
u should now be able to turn pump around so u can see 3 hex head screws
The User Manual for this model was of no help ... other than to suggest unplugging the unit which you already did ...
I could not find specific error codes for your model ... but F06 on Hotpoint washers in general have two definitions for F06:
F06 - Door lock fault
Issue: Washing Machines door cannot be opened or closed / when the door is closed the machine the programme will not start.
F06 - Program selector dial
Since you are having door issues ... then I would say the door lock is indeed the problem.
Check to make sure there is not any debris in the door lock insert, but my guess is that is not your problem.
It could be the latch on the door or the lock switch mechanism in the machine housing. Odds are it is the locking mechanism
Here is a Hotpoint You Tube on how to replace ... but it is not for your specific model
https://www.youtube.com/watch?v=p14EEa4AYGM
Good luck with your troubleshooting!
with the gas still off, remove the offending part, and replace it. Depending on the model, they can be easy to replace, or some are difficult. Some have no wires, others will. It's possible the part can be repaired, but finding someone with the know how and tools to do so will be difficult at best. Hopefully you have somewhere reasonably close that sells parts.
From the information you have supplied, I suspect that the door interlock switch may be faulty. But without more information, it is difficult to be certain.
I hope this helps?