20 Most Recent Hyundai ImageQuest LM1510A 15 in. Flat Panel LCD Monitor - Page 3 Questions & Answers

Hi,
This message ususally appears when a certain program has a requirement to run it. And if your display does not meet that, that is the time you will get this error message. Try to check the requirement of the software that you are installing and check your display information on the comptuer see if its conaptible.

Thank you for using Fixya. Your REcommendation is highly appreciated for the free support.

The problem you are describing is in the inverter board that powers the back lights behind the screen. The cause is bad capacitors in most cases and develop a bulge at the top indicating it is open. Repairs can be attempted or the board replaced.

It could be that you have a defective drive. Attempt to return the drive and explain that you believe that it is a defective product and ask for a replacement or a refund.

Hi,

You have posted the problem under "Hard Drives" section.

Kindly submit the question under Hyundai Genesis section on the website by clicking this link so that the best car experts can view and post a solution to the problem.

On the page which opens, type the question in the "Ask an Expert" box on the right hand side of the page and click on "Post a problem" button.

Thanks for using FixYa.

One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect your hard drive Test the leads that attach to your ((hard drive from the motherboard)) or replace all the leads that attach to your hard drive including electrical extensions + IDE,SATA and the ones that attach from your ((motherboard to hard drive)) make sure all leads that are attached to your drives dvd\cd 3 1/2 inch floppy have secure connections and are not faulty even the electic extensions or just replace them they are probably old and faulty a computer needs its connections to have an end so any faulty leads will end up with a computer error hope this helps

Turn Off the computer, now as soon as you hit the power button, keep on holding "Alt" key & keep on tapping "F10 key,ie: Alt+F10, it will open the recovery console ,select full factory restore and follow on screen instruction. (Note:this will erase all datas on the computer)

Hope this helps

You can find a replacement power adapter from your local electronics store, just bring the dead one with you so you can match up the correct voltage requirements and the bullet connector for the right size. If not try ebay, you will probably find a replacement on that site

Generally this comes from a few things

an oxygen sensor for the vehicle is bad, a vaccum hose is bad or a unit in the vaccum system is bad.

Hi; the upper part of your keyboard closest to the screen or the last row of keys contains a BRIGHTNESS key...

Press and hold the Fn key (usually italic and purple color) and press the Brightness (sometimes depicted by a bright bulb) key and observe if there's a change in brightness...remember to hold down the Fn key while adjusting the brightness. I hope this helps since you did not mention computer type or keyboard arrangement!

I'm assuming you have the sound cable plugged into the back of the monitor and then into the computer. If not, do it. Then go through the steps you normally would to check sound--are the drivers installed, is the sound on (not muted) etc. Are the speakers turned on by the controls on the monitor itself?
If none of these work, go buy external speakers.

Mine did the same the other day and all I had to do was replace the fuse in the plug. Just a thought if your monitor gets power direct and not through the PC
Good Luck

That's one hell of a PC monitor you've got!