20 Most Recent Miele 300 Front Load Washer - Page 8 Questions & Answers

Hi dear. Your machine needs new shock absorbers and drum tension springs replacement. I can advise to contact your local Miele center. Thanks.

fix the leak.

the unit has a brake you cannot spin the drum in that way,with the back off there should be a lever with a cable on it pull the lever back and get someone to try the bowl then

My tip: call the service department and ask them what the problem should be. If they refuse to answer, just ask over and over and over again until somebody will finally be connected to you which has to tell you how and what. If a company can repair it, they HAVE to give at least an answer to what is broken.

The motherboard governs the release of the door so I'm afraid you need to contact plumber. you could try unplugging it and seeing if it will release after few minutes

Miele washers have a small panel on front toward bottom of machine. Flip this panel open with the key provided inside the soap dispenser drawer. There should be a small orange coloured ring which you pull to release the door. To cancel program press and hold the start button for about 5 or so seconds. this should give you the option of cancelling the program. Hope this may help cheers from down under

Must be chocked with powder hot water should disolve it.

It stops because your water level sensor has detected the load point water level. More than likely the timer mechanism or the motor is fried. You can test these using a good Volt/Ohm meter. Be sure to disconnect the power before doing anything to a washer. Unless it's a lose connection or bad switch, it's usually more cost effective to replace the washer.

TRY TO USE DIFFERENT PROGRAMM, BECAUSE SOMETIMES THE PROGRAMM GET STUCK ON ONE.

One of the springs has probably come off,take off the top and check all the spring attachments.

open up and see if any brackets are bent or broken

Is water actually turned on? Are hose and valve screens clear of debris? Are hot and cold water hoses reversed?

Sounds Like it hasn't drained, or thinks there is still water in it. Take the drain hose out of the standpipe and place into a bowl. This will allow the machine to drain into the bowl. You'll need to then check the drain pump to find out why it hasn't drained....normally something like a hair pin stuck in the impellor stopping it turning

Either power supply problem or a control board issue.