20 Most Recent Comet BXD 2525 G Pressure Washer Pump - Page 2 Questions & Answers

From the hydraulic pump. there should be a little nub to place the hose on

If you are using gasoline that has alcohol in it for air pollution control, it may have ruined the seals in the carb.

Hi, Clean out inlet filter(s). There maybe more than 1 filter to clean out. Good luck.

Check your air filter, its probably clogged. remove it and start. if it continues to run, the filter needs to be replaced.

With out a diagram i cannot say for sure but i kinda doubt that it has to do with your by-pass.

Hi: Some things to check: Is the gas old or contaminated with water. Change it if you are unsure. Are you getting a spark? To check this: BE CAREFUL. Remove the plug. Plug it back into its wire. Hold it WITH INSULATED PLIERS so the tip is close to the metal frame of the machine and have someone pull the starter cord. The plug should spark.

the water inlet needs a gasket like all hose connections. If its gone the pump may be starving for water.

sounds like nozzle is blocked.small bits of grit jam nozzle unscrew and make sure its clear turn water on and pull trigger to see if gun trigger works,then refit nozzle check again for spray.if clear start up and try out.if no go then pump probably needs cleaning and relubing seals.

Ensure the membrane is protected with sand before laying the stone to avoid piercing the membrane.

As a customer, the advantage is that I don't have to drive to the florist. Saves time and gas. I could make a phone call, but then I wouldn't see the available flowers.

Reprogramming the Chipper Champ 2 chip sorting machine after the programming has been lost can be a bit tricky without access to the specific manual or instructions for that particular machine. However, I can provide some general guidance on how you might approach the reprogramming process: 1. **Consult the Manual**: The first step should always be to consult the manual or documentation provided by the manufacturer for the Chipper Champ 2 machine. The manual typically contains detailed instructions on how to program and operate the machine. If you don't have a physical copy of the manual, you may be able to find it online on the manufacturer's website or by contacting their customer support. 2. **Factory Reset**: Many electronic devices, including chip sorting machines, have a factory reset option that allows you to restore the device to its original settings. Look for a factory reset procedure in the manual or try pressing a combination of buttons on the machine to initiate the reset process. Keep in mind that a factory reset will erase all existing programming and settings, so use this option with caution. 3. **Button Combinations**: If the factory reset option is not available or doesn't work, you may need to reprogram the machine manually using button combinations or sequences. This typically involves pressing specific buttons in a certain order to access different programming menus and settings. Without specific instructions for the Chipper Champ 2 machine, this process may require some trial and error. 4. **Contact Manufacturer Support**: If you're still having trouble reprogramming the machine, consider reaching out to the manufacturer's customer support for assistance. They may be able to provide you with step-by-step instructions or walk you through the reprogramming process over the phone or via email. 5. **Training or Service Technician**: If none of the above methods work or if you're not comfortable attempting to reprogram the machine yourself, consider requesting training from the manufacturer or hiring a service technician to assist you. They can ensure that the machine is programmed correctly and provide guidance on its operation. Remember to exercise caution when attempting to reprogram or reset electronic devices, especially those used in a professional setting like a casino. Making incorrect changes to the programming could lead to errors or malfunctions in the machine's operation. If you're unsure about any steps, it's best to seek assistance from someone with experience or expertise in handling the specific machine.