20 Most Recent
HP LaserJet IIIp Printer - Page 9 Questions & Answers
Hp cm2320 mfp
there is paper inside machine, look behind the fuser or inside duplex unit
Hp laser jet printer 2055 problem output bin in full?
If you have already removed the paper from the output bin, check the delivery flaps to make sure they move freely. If they do, remove the top and make sure the sensor flag isn't broken and that the sensor is connected and undamaged. If it is connected and undamaged, check connector J213 on the engine controller is seated correctly. If it is, you probably need to replace the output bin sensor. See attached video
Model 2820. How do I solve engine error?
Try Engine test:turn on device open tray 1 and load paper (1 is the manual feeder)when you open tray 1 there's an engine-test switch, found it and press itEngine error are also cause too much resistance from toner, fusor or gears. Remove toner and check that it roll with your fingers on gears, and do same with fusor (could be very hot warning - should be hard move it but not too much) and with printer off and fusor removed check if you can move any gear manually (this can be harder but will help you determine if it's board error or resistance cause a gear problem).Any previous error happened with the printer can help to diagnose (jams, power off while printing...)
Out put jam in the printer 2600n hp
This could be a fuser issue or a paper exit sensor issue. Please take out the fuser and check the pressure roller. Be careful, the fuser is extremely hot.
HP 400 stuck initializing
79 is an firmware error. Try to update the firmware. You can find the file on HP website, on the Drivers and Support section. There must be also the procedure to execute the update.
Not finding what you are looking for?