20 Most Recent
Electrolux EIFLS55IIW - Page 5 Questions & Answers
My electrolux EWF14012 washing machine stops with water safety alert What do I do
Ok when this happens what it is is water has leaked into the base of the washer and activated the flood switch.
What you need to do is pull the washer out and lean it 45 degress backwards. This will allow the water to drain from the base so you may need a towel for that part.
Once the water is out the flood switch will reset itself and clear this fault. Then see how it goes from there.
But if it happens again then something is leak under there and you need to find the fault and fix it to sort it.
But if you do the above then you should be able to sort it from there.
Electrolux washer--door striker was broken, I repaired without replacing lock. Close door, now won't release. Pulled, pried, unplugged and re-booted. Ideas to open (and replace door lock)?? thx
Not sure about Electrolux but the door striker or keeper of many front loaders incorporates a timer mechanism that prevents the door opening for a minute after the wash programme has ended.
Inside the striker of my washer, there is a heating element and a bimetal strip and if the mechanism fails when the door is locked it is very difficult to defeat.
On one machine I had to work inside the cabinet with a hammer and a long chisel to break up the striker in order to open the door and replace the striker.
One thought occurs - if your machine is a modern wholly computerised type, it might be necessary to tell the brain a repair has been carried out before the machine will work correctly. That would mean a visit from a service engineer who will connect his laptop...
Perhaps a research call to the experts will shed more light...
Electrolux washing machine showing error 33(no interlock). what do I do?thanks
Hey Desmond, thank you for your inquiry!
From my understanding your Electrolux washer is displaying an error code of 33. I am showing that is an invalid error code. This could be a miscommunication within your control panel. I would suggest performing a reset on your washer and you can do that by disconnecting power from it for at least ten minutes. If the reset does not help correct the issue and the error code comes back please comment back. Also, let us know your model number. You can locate the model number of the door frame of your washer. Once I have that information I would be able to assist you further. -Matt
Not finding what you are looking for?
otherwise could be:Tap closed or water pressure too low; drain pipe improperlypositioned; water fill solenoid valve faulty; leaks from water circuit onpressure switch; pressure switch faulty; wiring faulty; main PCBfaulty.Dado
