20 Most Recent
Invacare 1109530 Mk 5 Nx Dk-pma02 Power Module Controller Mk5 - Page 3 Questions & Answers
My pronto m51 sure step service light is flashing
sarah check the joystick cable try unplugging it from the rear of the joystick and plugging it back in then unplug it at the back of the chair and plug it back then turn the chair on to see if you are still getting 7 flashes. If you are then you have one of 2 problems the joystick cable somehow is bad or the joystick itself has got a problem try the cables first to see if it fixes the problem If Medicare paid for the chair then they will pay for most of the repair Contact Roadrunner Mobility @ 1-800-467-2668 Hope this helps you
Mobility scooter lights wont turn off
It really can only be one thing. Somewhere on your scooter is a switch for the lights. Try turning it off. If that doesn't work the switch is faulty
What does a blinking yellow light mean on INVACARE ponto
it indicates that the SB900 battery has been placed in the charger incorrectly. The battery is positioned "backwards." That is, the label is still facing up but the orientation has been reversed for the positive and negative ends.
When I drive forward and move the joystick to center the chair is still moving for the few fit before stops.
If the brake is applied by electromagnetism, power must be supplied to the coils by either manual or electronic switching.
I suggest you investigate the circuit to discover how the power should be supplied to the brake coils and then it will be easier to trace the fault.
As a matter of not unrelated interest, it is fairly usual to arrange the wiring/switching so when power isn't being supplied to a low voltage DC motor the motor terminals are shorted. When being pushed the motor becomes a generator and the input becomes and output and so shorting that output makes the motor self-braking to some extent - this is why car windscreen wipers are able to stop almost instantly...
Flow meter on my Invacare Perfecto2 oxygen concentrator not working. The knob turns but the ball doesn't move.
If by the "ball" you're referring to the type of flow gauge that works by a stream of gas pushing up a small plastic ball in a clear tube or drilled piece of clear plastic, then the ball is either stuck somehow (moisture in its tube might do that by causing some friction), or it's showing there's no flow of oxygen enriched air, meaning the concentrator itself is not working. Can you feel some air flow if you hold the outlet towards the skin on your cheek?
MK5 SPJ+ Joystick will not shut off
I have an Invacare Pronto M91 with the SPJ+ controller and it was doing the exact thing you describe. Easy to turn on, but very difficult or impossible to turn off. I replaced the keypad on the controller and now it works like a champ. Easy on-Easy off!! I believe the key bad buttons have graphite on them and then it wears off with time, causing the above issue. They can be ordered for about $32 from Monsterscooterparts.com
Not finding what you are looking for?