20 Most Recent Zanussi F1045W Front Load Washer - Page 7 Questions & Answers

If the washer won't drain there might be a clogged pump or hose. It's common for small socks or other small clothing items to get into the water drain system and clog the hose leading to the pump or the pump itself. Remove the hoses from the pump in order to remove the article of clothing.

E20 means problem with drain water phase Only two things need to be checked: - Drain pump could be clogged or no power supply (the last means faulty drain pump, faulty electronic or wiring between drain pump and electronic. - Your home drainage system (in the wall) is clogged (This is very easy to check visually, disconnect the drain hose from your siphon and put water in some container or in washbasin.) Dado

Don't know model# try utbe

9 possible things to check per the web page below: https://www.support.emea.zanussi.com/en-uk/Laundry/01_Washing_Machine/The_washing_machine_is_displaying_E10_C1

Page 9 of this manual, if this is the same model, may help turn off acoustic signals. It shows an image of a P and another image of a button to turn off. https://manuall.co.uk/zanussi-zwf-91483-wr-lindo-300-washing-machine/

check heater element

This can be due to error in the control board. Shut down and remove plug and when switched on press down the start/stop button. If the error does not clear this can be a fault in the motor drive within the control panel board.Remove the panel and check the connections to the motor, check the motor and the capacitor to the motor or if the motor is jammed.

Try carbon brushes

NTC2 Sensor fault. Either the sensor is bad or... Wiring to the sensor or... Faulty electronic board

i50 - on your dishwasher means "Motor triac short-circuited" (the washing pump runs uncontrolled at maximum speed) Remedy: it is mostly circuit board faulty Dado

Ed4 - means: Relay that switches the power between the washing and drying heating element (in the WD PCB). Could be: Wiring faulty; Electrical current leak between heating element and ground; WD board faulty; Main PCB faulty When this malfunction occurs the cycle stops with door open. Dado

Got a zanuzzoe Electrolux. Aqua cycle filter button is orange won't reset