20 Most Recent
Zanussi F1045W Front Load Washer - Page 4 Questions & Answers
Loud banging in spin cycle zanussi aqua cycle
if you can get the front plate off you will probably notice that the drum stabilizer roller has either fallen off or is damaged. This part is replaceable and should be no more than 20 bucks.
I have a Zanussi WDA1055W washer/dryer. I never
the water should only be filling up to approc 2in above the drum bottom...........look inside when its filling..........if its filling to nearly the bottom of the door you either have a faulty pressure switch or grit/dirt in the internal filter.......as a result the machine will not spin if there is too much weight in the drum
F1045w spin prob
unfortunately that sounds like your timer is faulty.......in Ireland a timer is now costing approx €100-€150 euro so its not worth replacing outside of warranty
Bearings need changing
No I think not , it is really a job for an experienced engineer , but how do you know the bearings need changing?
Fx1365 door will not lock followed by four bleeps
From what you say,I would be looking for a fault on the programmer, sounds like you are not getting a neutral feed.
By shorting out the lock you have created a circuit through live and common, causing the m/c to operate.
Check carbons in motor.
Zanussi wj1054 front load
Check the water level pressure chamber for a partial blockage, this can cause all sorts of problems.
Washer wont spin
is it draining ok or does it m ake any noises as if trying to spin?
Zanussi Aqualux washing machine
the belt is a tight fit so you need some strength
remove top. loop belt over the motor pulley and start belt onto drum pulley. turn drum pulley and belt will work its way on. there is just enough room to do this
Machine will not empty or rinse
Put off the machine. After 3 or 4 minutes put the control to "spin only" & put the machine on. If this does not work you hv a drain problem which shd be checked......
Kenmore model #110.22802100 drains but no spin
If it is draining, then the motor is ok.
If it is agitating properly, then the motor coupler is ok.
This leaves the gearcase, clutch, basketdrive(brake), basket drive block, or timer.
Raise the lid and hold the lid switch down. Start a rinse cycle and let it go through the cycle. It should drain the water, then stop the motor for a split second then kick the motor back in and start spinning. If it doesn't drop out that split second then the timer is holding it in neutral drain. You can recreate this by letting it start draining, then let off the lid switch, then depressing it again. The basket should start spinning. If not,
Raise the lid and hold the lid switch closed. Start it in spin and see if you can get it started spinning by hand. If so you probably have a slipping clutch.
Post back with any questions.
You can go to sears.com, click on parts, and enter your model number and see parts diagrams of the washer. This can be helpful.
Zanussi F1045W Front Load
indicated low water pressure from your external supply or blocked filters in the fill hose. turn water off, remove hose and check filter in end of hose - it is just a bit of gauze. also look into the valve and clean out if needed
Zanuusi brushes
I'm pretty sure that it is the brushes;) It's pretty easy, but you must know what you are doing:)
Refitting door gasket - F1045w Help
Hello!!
You need to dismantle part of the washing machine to gain access to the
huge clips that hold the seal in place on the INSIDE of the machine
casing.
Not finding what you are looking for?