20 Most Recent
Pride Jazzy 600 JAZZY 600 - Page 2 Questions & Answers
Pride GoGo mobility scooter cuts off.
Get a can of Electrical Contact Cleaner spray and separate any electrical connectors that you can see, and re-make the connection. You have a bad connection somewhere that is losing contact with a bump. The most likely places are any from the battery, or any to the controller. Make sure the two connector halves are fully locked in place. Some have fuses, some have breakers, check the connections there as well.
You say it has only done 8 miles. If you bought it new, it is under dealer and maker warranty.
I was hoping to find you a manual, but 'GoGo' is a range of models.
https://www.google.com/search?q=Pride+GoGo+manual
Shutting off on bumps is a known issue caused by the battery box bumping.
https://www.google.com/search?q=Pride+GoGo+shuts+off+on+a+bump
..
I need help with my pride victory 10 scooter.
AN EV WHEEL CHAIR;
1: bad battery always tops the list;.
2: battery lugs rusty /loose
3: battery charger bad. (lies to you, too)
4: something far worse shorts or bad EV motor,excessive current)
5: something that causes motor drive to bind up . overloading motor
ask shop find this and do all tests to find it. ask them?
My Pride igo foldable wheelchair beeps and will not go.
Do you get any flashes from the controller lights? This is usually the way you diagnose errors. A high number of flashes/beeps often means there is an issue with the controller or joystick.
Batteries are only fitted if they are needed so a 'spare' battery isn't very likely. Most wheel chairs and scooters need a powerful battery to spin the electric motor so a pair of batteries are used. The two batteries also act as a counter weight to keep the chair upright.
They are normally fitted in a 'serial' or 'in-line' set up. Basically into one battery, across to the second battery then out through the second battery.
Does anyone know what the code 4 flashes followed by 3 flashes means on a Pride CelebrityX Sport
A 3 then 4 flash sequence is showing the Freewheel Lever is in the freewheel position and the scooter cannot power the wheels. Turn off the scooter move the lever firmly in both direction 2 or 3 times then leave in the 'Drive' position. Turn the key back to the On position and check to see if the flashes have stopped.
As Scooters age these switches can wear out and fail and all you can do is replace the switch assembly as they are often a 'Non Repairable' part.
Not finding what you are looking for?