20 Most Recent Honda 86 87 88 89 Accord Alternator Lxi Sei - Page 5 Questions & Answers

Hello dear, would you consider buying a new generator? Generator Diesel Generator Cummins Generator Volvo Generator Perkins... If you can start your generator normally, you can analyze the reasons through the following article: Why Diesel Generator Fail to Start Simple Ways to Deal with Diesel Generator Failure Hope it works for you.

Honda EU3000is Owner Manual http://www.ipspower.com/images/documents/technical-information/PE-Carburetor-Troubleshooting-Manual-Compressed.pdf http://www.tonysrv.com/docs/generator_brochure.pdf

if you are using a lead that has a active , a neutral and a ground wire in the lead , there is no real reason to ground the gen set itself the neutral will not be bonded to the frame as that would create a possible short during operation the circuit is simple --active is the power wire --neutral is the return wire from the applications and the ground wire is for dead shorts and to prevent electrocution

undo the fuel line and the mounting bolts and slide it out from under the frame

a GX390 Honda Motor but the used generator stator can be different cannot give more suggestions then measuring the circuitbreaker it can be broken the suggestion 60 mf capacitor can have trouble and electronic modul and bridge rectifier for some other dc connectors the coil diodes inside the stator. several options to go.

As far as I know this generator has not a manual activated valve opener. Therefor the exhaust valve may be stuck in the open position. Spray the valve stem/shaft at both side where it enters the casing with penetrating oil and leave for a while. (Hour or so). Try then to get the valve to move freely by moving the valve up and down. Use pliers but the jaws must be covered with a thick cloth as not to damage or scrape the valve stem. Ps. if the inlet valve moves but the outlet doesn't then the outlet is just stuck and need to be loosened.

will it blow any circuit? if so, the a/c has an electric problem. will the a/c run when plugged into a service power supply?

This generator will run an a/c unit up to 13500 btus and is good for 2800 watts. This is a small generator, the nameplate rating numbers need to jive before overloading the energy supply.

If the generator is an auto stop/start type for standby use, it would seem those solenoids are the reason why fuel isn't getting through. It would be a fairly sensible method of stopping the engine remotely. An auto start/stop generator would need a battery for starting purposes, a battery that would presumably also provide current to energise those solenoids and allow fuel to flow. I suggest you refer to the instruction manual in the first instance...

Was it ever electrically overloaded?

Try the tube that runs between the fuel tank and the carburetor. I have seen them crack since the tank is stationary and the engine is on rubber motor mounts. That line is in constant motion.

You have to pull the rear (muffler end) cover, rear muffler protector (the metal vent), the rear handle, the lower end plate, and the fiber muffler protector so you have access to the head cover. Remove the head cover, disconnecting the breather tube as you do it. Turn the engine (using pull handle) to top dead center compression (both valves fully closed). Use feeler gauge to check the valve clearance between the rocker arm and the valve stem. Intake should be .15mm +/- .02mm (.006in +/- .001) Exhaust should be .20mm +/- .02mm (.008in +/- .001) Adjust as needed by loosening the rocker arm pivot locking nut and adjusting the rocker arm pivot. Tighten the locking nut once set. Put it all back together. :)