20 Most Recent Generac Inverter Ix2000 Gas Portable Generator......new - Page 5 Questions & Answers

Look by the control box, either inside or side of the control box.

https://www.generac.com/service-support Generac Power Systems Customer Support for Generac Generators Pressure...

See if this helps, you can search back and forth within the link. Valves settings are .006int/.008exh Onan GRCA Service Manual Valve Clearance lash Adjustment

I need to know the open circuit voltage of the generator, whether DC or AC and then what voltage and current you wish to obtain and regulate to. Thanks

You need a frequency converter - however, these are not cheap since they are intended for industrial applications - usually rated to drive motors. Depending on the device that you are driving, you might be able to adapt it for a DC input and convert the generator output to DC, or modify it to accept a 60 Hz input. Frequency Converters AC Power Supplies Frequency Converters

hi it looks that a wire feeding the little solenoid switch come away or damage ( this solenoid switch it turns the fuel on when the engine gets activated ) a// faulty solenoid b// no electric supply to solenoid

hi replace the rpm sensor

hi check for compression on cylinder and ignition timing / and ensure of fuel getting in the combustion

That may be normal. Some generators have to have the magnetic field excited in order to increase the magnetic lines of force for the armature to cut through.

check your frequency of the ac, if this is high, then adjust the rpms. If that is fine and it is shutting down, check overspeed adjustment on control board if it has it.

Usually the generator will shut down if the ac is not present coming out of the generator. You stated that it still runs but no power on the output. Check your breakers first to make sure they are working properly. Depending on what board you have you can check to see if ac is present getting back to the board as well. If your board does not have this then they are using the frequency as a safety disconnect feature. That would lead you back to the regulator or loose connection or..dirty slip rings if this unit has brushes.

Something might be wrong with your automatic transfer switch.

You may have to snap a picture of your generic wheelhouse generator and upload here for further help/assistance please Generac Power Solutions Service and Support Online Product Support Generac...