Kohler OnCue Generator Management System For 14RES/20RES Models - Page 4 - Answered Questions & Fixed issues
Kohler not running after warmed up.
IMPORTANT replace in first priority the sparkplug (control the oil level) tankairiation if not cured The ignition coil can be thermical damaged, (try coldspray to test on it ) if ordering have high priorty on motornumber and year of build by your model to prevent there are no marketing technical upgrade/ modifications are made because then you get no spark to see either, if get the wrong for the different flywheel
11/2/2016 12:36:43 PM •
Kohler...
•
Answered
on Nov 02, 2016
•
54 views
Gen set blows fuse
no
a fuse is there to protect the circuit and the genset
check why the de-icer is pulling so many amps as the problem may be in that unit
a 10 amp outlet has a maximum current capacity of 10 amps as that is the current allowable from the gen set and wire capacity
even if you had an outlet with 15 amp rating , it would still be blowing fuses as the 16 amps is above the allowable current draw
you would need a 20 amp outlet ( difficult to get unless it is in a house power board and are normally reserved for hot water systems , stoves and other high current usage units and are normally then not outlets but hard wired in to a circuit breaker
8/10/2016 11:36:37 PM •
Kohler...
•
Answered
on Aug 10, 2016
•
399 views
K300 gas engine. What is output shaft dia and is it keyed?
www.ebay.com/bhp/3-4-keyed-
shaft
eBay3/4" Dia. Steel Shaft / Rod 18" Long. ( Keyed 3/16 "both ends ). $34.21 .... 3/4" to 1" inch w/Step Key Gas Engine pulley Crank Shaft Sleeve adapter Predator.
engine4less.com/ALL-Vertical-
shaft-
Kohler-Engines/
This engine has same mounting and shaft as all KOHLER Single cylinder ... 1"diameter x 3-5/32" length keyed VERTICAL (UP and DOWN ' ) crankshaft. Please ...
11/6/2015 2:24:53 AM •
Kohler...
•
Answered
on Nov 06, 2015
•
196 views
Not finding what you are looking for?