20 Most Recent Kohler 30rz82 30kw Generator Power System Fast Response Nat Gas 890 Hours - Page 7 Questions & Answers

0helpful
1answer

Kohler 6eod

Under voltage would be low output voltage from the generator power head. Verify that the motor is funning at full speed to check the output voltage. Low battery is telling you that the starting battery has low voltage. This could be because the battery is bad or that the alternator is not charging the battery
5/23/2014 5:58:43 PM • Kohler... • Answered on May 23, 2014
0helpful
1answer

How to identify older models and year manufactured?

Hi Jesse, I didn't have a model / serial number to try, but I suspect the date you're looking for is coded in one or both of those numbers. Have a look here & plug the requested info in to see if it returns the info you're after. Good luck! Engine Identification
5/12/2014 11:41:10 PM • Kohler... • Answered on May 12, 2014
0answers
0answers
0answers
0answers

Error Code LRC

Be the first to answer 2/4/2014 5:52:06 PM • Kohler... • Posted on Feb 04, 2014Be the first to answer
0answers

Error code LRC

Be the first to answer 2/4/2014 5:50:27 PM • Kohler... • Posted on Feb 04, 2014Be the first to answer
0answers
0answers
0helpful
1answer

Generator output 12 ac at both 110 and 220, when flash it increase to 20, 38 ac, then decrease back to 12ac after a while, any suggestions? thanks

You have overloaded the generator by plugging in too many appliances at one time. A capacitor has likely blown and someone with electrical knowledge needs to troubleshoot and find the damaged part. Appliances draw high amperage and when they cycle on they draw 50 percent or more amps, so a refrigerator that might draw 1000 amps could jump to 1500 when the compressor cycles on. If two or more appliances cycle on at the same time, they will exceed the capacity of the generator, that is unless you have a very large unit.
12/6/2013 6:35:12 AM • Kohler... • Answered on Dec 06, 2013
0helpful
1answer

First start up

Try disconencting the remote start wires between the transfer switch and the generator, if ot still does it you have a bad control board. If it stops, then check the transfer switch for correct wiring of utility and generator power wires, also check with an ohm meter if the run contacts in the transfer switch are closed, that would indicate loss of sensing, or bad board
12/1/2013 10:51:28 PM • Kohler... • Answered on Dec 01, 2013
0helpful
1answer

Kohler boat genny surges

Check fuel supply, carb etc
11/27/2013 1:16:29 AM • Kohler... • Answered on Nov 27, 2013
0helpful
1answer

Rdt-cfnc-0100a

Disconnect the control wires and see if it still does it
11/27/2013 1:15:32 AM • Kohler... • Answered on Nov 27, 2013
0helpful
1answer

Kohler Confidant 4 puts out to much voltage

Are you running the gen and plugging in the RV at the same time? I assume it is wired right and you have a transfer switch? Are you saying the voltage is fine when the RV isn't plugged in?
11/27/2013 1:15:00 AM • Kohler... • Answered on Nov 27, 2013
Not finding what you are looking for?
Kohler 30rz82 30kw Generator Power System Fast Response Nat Gas 890 Hours Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Kohler Electrical Supplies Experts

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66830 Answers

Are you a Kohler Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Kohler Electrical Supplies

  • Kohler Electrical Supplies

Most Popular Question

cylinder head torque specs 23 horse

  • Electrical Supplies
Loading...