Creative Labs Sound Blaster Live! 5.1 Sound Card - Answered Questions & Fixed issues
Sound blaster sb1070 driver for windows 7
Save hours of searching online or wasting money on HELP NUMBER +1 833 272 0777unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
11/21/2018 6:04:30 PM •
Creative Labs...
•
Answered
on Nov 21, 2018
•
2,969 views
I just installed Creative PCI Sound Blaster 5.1VX
These systems sense the speakers and you cannot use a Y connector on them. You need to get the individual speakers connected to the card and see how it performs. Also check the device manager in windows to see if it show any errors and last but not least what is the motherboard, the operating system?
A coma computer enthusiast has installed an old
ISA is a very old technology and cards usually require switches or links to be set to avoid conflicts with other cards. ISA is not plug-n-play like PCI or PCI-e.
The software talks to an ISA card by knowing parameters such as IRQ number, DMA number, address range. These values may be permanently set on some cards, while others allow changing via the DIL switches or jumper links. To get two ISA cards working in one PC, the two cards need to use their own IRQ, DMA & address ranges. Make sure there are no conflicts of settings on the sound card and the tape drive card.
Try changing the settings on one of the cards. The tape drive may be the easiest for this. The tape drive is probably connected via a ISA to SCSI interface card. This should have DIP switches or Links to allow the above settings to be changed.
Sound does not work
Try going to with the Creative sound mixer or the windows sound mixer to check if by any chance the output is muted. Also I believe that this is quite an old card so maybe with newer versions of windows it might run into driver problems. If I remember rightly on this card there was an option to choose between digital or analogue output most probably you have it set on digital. You need to go through the sound card settings in the software that came with it and change that setting to analogue.
Driver sb1070
amar creative 5.1 model no sb 1071 ami windo7 dard diver chay
I have the Soundblaster 5.1VX
click start control panel
sounds and audio devices select advanced there might be a tick in the mute box
untick it or select audio from the microphone drop down list make sure you
have the right one selected and in the volume box make sure the microphone box
has a tick in it or select the voice tab and make sure that you have the right
media selected also select volume make sure the box for microphone has a tick
in it
hope this helps
Not finding what you are looking for?