20 Most Recent
Dell 3100cn Laser Printer - Page 5 Questions & Answers
Dell 3100cn printer leaves a blank strip
The following table should help
Contamination in the laser path - 1. Clean the laser path. (Remove the laser/scanner assembly and clean the lens.) 2. Replace the laser/scanner assembly
Defective fuser - Replace the fuser assembly.
Lack of toner or faulty toner cartridge - Redistribute the toner in the toner cartridge. If the problem continues, replace the toner cartridge.
Dirty Corona Wire - Clean the Corona Wire.
Defective Drum - Mostly applies to B&W printers. Clean the drum or replace the drum.
Paper Jam Fuser 077-104
Most likely you will have to replace the fuser. Also I would inspect all pick up rollers and make sure they are all textured with no smooth or bald spots. Bad rollers are the #1 cause of jams. Also if you hear any clicking you may have a bad gear.
Will not sense paper in the manual tray
1. The manual feed tray should have a sensor that is usually black in color, if not in place, that may be the reason for your problem, 2. This sensor must be clean and freeof obstructions in order to function correctly, sometimes not seeing the sensor, so you can see is "trigger" that will operate the sensor. However, if you can see that everything is in order you should take it to a service center.Note: Before this check your printer settings, often the printer is set to take alternatepaper trays ...good luck
Not finding what you are looking for?