20 Most Recent Indesit W 123 Front Load Washer - Page 3 Questions & Answers

code showing h20 is the clue water is also known as h20,so your problem is the inlet valve letting the water into the back of your machine needs replaced or water pipe is kinked and no water is at the supply,. these valves are cheap at 10 dollars,adrian.....

There should be a LOCK ICON with an LED to tell you whether the Front Load door is locked or unlocked. If the machine door wont open after the wash cycle, the dryer function or the drainage function hasnt completed. What you can try is just choose the dryer function after the completed wash cycle if the problem arises again. IF that doesnt work, then look at bottom of the machine; there should be a flap present which you generally open up to get to the manual drainage valve.. you just pull that open and drain any leftover water .. After the water recedes.. the LOCK icon should be off and you can then open the front load door

you will need to unplug the machine at the mains, give it two minutes and the auto door lock will release your duvet, however start saving the pennies as your pcb is knackered and you'll be looking at about £200 to fix it

In order to answer the question I need more information, What is jamming what is the actual fault

this may sound silly but just had the same problem changed the pump and it works fine now, if the pump does not work it wont let the washer start

Tom, I'm having exactly the same problem, Have you managed to solve it? The Service center will no even tell me what's wrong with (they're quite keen to get me to arrange a visit from their engineer for £110 though). Thanks

Use a different brand conditioner. The one you have is too thick (viscous). Or, add about 1/2 as much and fill the rest of the container with water to thin it out.

depends on what lights are flashing this is your fault code

read the followin: http://www.vacuflo.ie/installation_guide_existinghomes.pdf

would try changing the interlock unplug first regards jason

from what you wrote the signs are that the bearings have gone

Spray it with WD40 , take a minute or two and try removing it .