20 Most Recent
Smeg SUK92MFX5 Dual Fuel (Electric and Gas) Kitchen Range - Page 4 Questions & Answers
We have an IS7599 Smeg
You can suspend it by wires wrapped on the ducting at 3 equal point of the circumference. This is good for when there is no walls or support around. The manufacture of the ducting should also offer bands/ brackets to suspend or mount. Its really a easy job. Best of luck.
My Smeg oven heats up
Hello, my problem will soon be resolved by employing a professional smeg electrician who said I needed a new thermostat. Thank you for reading but I no longer need 'fixya' assistance this time around.
Hi the minimum flame on
Don't know the brand from that#, but Adj screw is typically inside the shaft. Need a long very thin screwdriver to get to it. I cannot see your repyl due to some tech issue w/ the site, so it may be a day or so before I can reply again. Please leave feedback for me if appropriate. Thanks
The oven is not heating
I assume this is electric. Check terminal end on heating element. If it is burnt use a stainless steel terminal end as anything else will burn up.
I dropper a jar of
ceramic tops can be replaced but not thateasy. worthwhile checking your house insurance as many policies cover breakage of fixed glass
Re Smeg 60cm electric
I have one for sale I am jus putting it up on ebay buy it and replace yours.
http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=110291356746
Need a replacement for one
try this...
Address:Brisbane Appliance Service Center Pty Ltd, 55 Ipswich Road, Woolloongabba
//');
} else {
document.write('Javascript must be enabled in order to use Google Maps.');
}
//]]>
Javascript must be enabled in order to use Google Maps.
Contact:
Phone (07) 3391 0360
The oven door won't close
the clips on these oven are canyilver type they can move out of position if opened abruptly .to refit correctly lift door upwards while pushing the bottom of the door inwards.you should feeel a strong resistance from the door springs.there should be a notch n the bottom of the hinge this should slot over the oven frame.if this does not solve the problem then the springs have probably gone on the hinges and will need to replace both hinge assemblies
Not finding what you are looking for?