PDF
When the power is turned on in terms of a wireless meter the screen should display "SEr" ... the UIU, when correctly paired the screen will display "RF Con" with a "tick". 5. The meter can then ... this means that the tamper latch has not ... If you have signal and the RF CON message on a meter that was previously paired then ...
ystar: If the conlog meter is showing rf-Con, it means power supply doesn't reach the meter at all its either Loss of phase from the transformer or a loose contact ...
Jan. 22, 2018 · 3 posts · 3 authors
Asking for a friend, He is using a wireless electrical meter, however on the meter it says: rF con He said it's a conlog, so I googled it and...
Jul. 29, 2015 - The power meter is really easy to understand. However, the meter will also throw some error symbols on the same display which we already ...
You need to start again. Turn off the speaker. On the Phone/Bluetooth click 'Forget This Device' for the speaker. Reboot the phone, and then turn on the speaker. Tell phone to search for Devices. Press the Bluetooth button on the speaker. This will correctly re-establish the pairing.
https://www.fixya.com/support/r26362721-pairing_bluetooth_devices
..
Check the capicator on the power supply which is only working on the SSB
mode. Many of the 148's had a bad cap installed at the MFG.
Sorry, I don't have the schematics available right now, but it is easy
enough to find.
IF it works, what are you questioning? It is rare for any antenna to have a flat SWR across the whole band. One has to ask what meter you are using and of course you know that you cannot measure SWR on SSB right?