Top 20 Nortel IP Phone 2002 NTDU91BD70E6 Questions & Answers


Answer> Manuals: If you want FREE manuals for your device, you must go directly to the maker of your hardware device. Look for their SUPPORT (Drivers and Downloads) and input the required data such as the Make, Mod. of the device in question. They will then take you to the proper section where Drivers and Manuals are located. Here you simply select the option you want to download and install your drivers or open a manual. Manuals often come down in PDF format and require Adobe Reader. Get Reader form http://www.Adobe.com .

Nortel Radio... | 141 views | 0 helpful votes


It obviously works, so it is NOT a fuse. The most likely cause is a poor antenna connection. This happens often. Unscrew the antenna. Use a continuity meter to check check each connector. Such as the one that screws into the radio, if the continuity meter "beeps" the connector is "grounded" and was installed improperly. Do not use that antenna until you fix it, you could blow the transmitter by using a "grounded" connector. Test it exactly the same way without the antenna attached. If you are not used to installing connectors, you could easily go through 2-6 before you get the hang of them.

Radio... | 231 views | 1 helpful votes


Use the AUX jack, the old cigarette lighter jack to get a 12V feed. It will work fine as long as you are not using a linear amplifier with the radio.

Radio... | 35 views | 0 helpful votes


Please see below. I believe that you have set the tuning to LOCK, hence the KEY symbol. I have done the same thing with other radios. I bet you never forget this!

Manual Tuning with Rotary Dial You can select a higher or lower frequency by turning ROTARY TUNING. Set FAST/FINE/LOCK to select the rotary tuning increments or to lock the ROTARY TUNING dial. The following table shows the tuning increments for the FAST and FINE settings. '------'------'-------'------'-------' ' ' FM ' LW ' MW ' SW ' '------'------'-------'------'-------' ' FAST ' 0.1 ' 9 kHz ' 9/10 ' 0.005 ' ' ' MHz ' ' kHz ' MHz ' '------'------'-------'------'-------' ' FINE ' 0.05 ' 1 kHz ' 1 kHz' 0.001 ' ' ' MHz ' ' ' MHz ' '------'------'-------'------'-------' To lock the ROTARY TUNING dial, set FAST/FINE/LOCK to lock. This keeps you from changing the frequency if you accidentally touch the dial. NOTE: This locks only the ROTARY TUNING dial.

Radio... | 38 views | 0 helpful votes


As a technician, I would think it’s more than likely a parent problem or it could be a battery dead on one of the devices and it cannot see it or there’s too many things generating that particular frequency in that area. Good luck

Radio... | 26 views | 1 helpful votes


You check your radio with other radio very near. If radio is hearing your transmission then it mean that your Radio Power Module not working if very near radio not listening you then your preamplifier and Power amplifier is not working, it mean your Radio Transmitter faulty, only Receiver is working, you consult with any Radio Service shop. One other thing if you have software also check Tx/Rx frequency it must be same for simplex operation.

Radio... | 39 views | 0 helpful votes


Try a reset. Hold down the power button for >15 seconds.

Radio... | 23 views | 0 helpful votes


search for instruction manual

Radio... | 39 views | 0 helpful votes


Hi. Google has the user manual at: blob:https://www.cleancss.com/723b15cc-34cb-4c4b-aec6-e3db91bc4499

The info you are looking for is in section 4. Basically you press the shift key to do want you want.

Good Luck.

Radio... | 31 views | 1 helpful votes


You would have a better chance of someone being able to help you if you post of the make and model of the radio. Base, mobile etc.

Radio... | 32 views | 0 helpful votes


time for an aftermarket replacement then. that's your best and cheapest step. you might check http://www.onlinecarstereo.com they usually have some really good prices on stereos there.

Radio... | 22 views | 0 helpful votes


Contact Uniden directly to inquire.

Radio... | 26 views | 0 helpful votes


Hello Jeff, I was looking for the user manual of your CB Radio Hatadi, to know what fuse it takes and there is no information
I would try the 5 Amp, I would place it and it would work for a long time to the BC Radio, checking that the fuse resists the transmission work
If it does not resist, I would put the 10 Amp and would do the same test
If it does not resist either, then you already have problems with the equipment
If so, look for a specialized technical service
I hope you can solve the problem
Greetings Franco Dosil
Hola Jeff, estuve buscando el manual de usuario de tu CB Radio Hatadi, para saber que fusible lleva y no hay informacion
Yo probar?a con el de 5 Amp, lo colocar?a y har?a funcionar por un rato largo al BC Radio, comprobando que el fusible resista el trabajo de trasmisi?n
Si no resiste, pondr?a el de 10 Amp y har?a la misma prueba
Si tampoco resiste, entonces ya tienes problemas en el equipo
Si es as? busca un servicio t?cnico especializado
Espero Puedas resolver el problema
Saludos Franco Dosil

Radio... | 31 views | 0 helpful votes


I think you will find the problem is in one of the microphone wires. The switch for TX/RX is in the mic, and if the RX wire opens up, you will not get any receive audio.

Radio... | 26 views | 0 helpful votes

Not finding what you are looking for?
Nortel IP Phone 2002 NTDU91BD70E6 Logo

3 questions posted

Ask a Question

Usually answered in minutes!

Top Nortel Radio Communications Experts

ka4iup
ka4iup

Level 3 Expert

4062 Answers

Norm Pearl

Level 2 Expert

108 Answers

Harrie

Level 3 Expert

6705 Answers

Are you a Nortel Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Nortel Radio Communications

  • Nortel Radio Communications

Most Popular Question

change message

  • Radio Communications
Loading...